Don't Worry About Low Park Power Again!
Today's RV's contain advanced electronics including computers, TV's, satellite receivers, microwave ovens, air conditioners and other sophisticated appliances. Poor power quality entering an RV can not only effect the longevity of electronic equipment and motors, but can lead to thousands of dollars in repairs and create frustrating, unnecessary travel delays.
In addition, the Surge Guard Voltage Regulators are the first boosters that include intelligence with easy-to-read LED status and fault indication panels. These LED's show ground status line conditions as well as indicate the under/over voltage conditions of each output line. This product is designed to be fault tolerant so that it can not be damaged by an open neutral that results in high voltage on one of the incoming lines.
In the Low Voltage (Boost) Mode the Surge Guard Voltage Regulator raises the output voltage by 10%over the incoming line voltage. In the Bypass (No Boost) Mode the unit becomes a bypass element and simply passes the input voltage directly to the output. In the bypass mode the unit exhibits minimal insertion loss. On the 50A power source, using our Model 10175, each line voltage control circuit operates independently so that an increase only occurs on the required line.
Using the Surge Guard Voltage Regulator in conjunction with a Surge Guard® RV power protection product provides the ultimate combination of low voltage and Surge Guard protection. The Surge Guard must be plugged in after or down stream of the Surge Guard Voltage Regulator. A variety of Surge Guard products protect your RV from: High/LowVoltage, Open Neutral, Miswired Pedestals, and Surges
Boosts as low as 95Volts
Provides a reliable source of power
Helps prevent low voltage damage to appliances
Easy-to-read LED Status and Fault Indication Panel
Fully automatic - Continuously monitors line voltage conditions
True bypass mode - input voltage is equal to output voltage
Increases voltage to an acceptable level
Mounting feet so unit does not sit in water
Optional mounting bracket for inside the RV
Rated 120V/240V, 50A
For use on single phase, 3-wire service
Can be used on a 120/208V, 3-wire network
Weight: 42 lbs.
Dimensions: 10.25”L x 10.25”Wx 5”H
Cord Length: 4-5 Feet
Mounting Feet Height: 2.5”
- (Optional) Mounting Plate Height: 0.75”