|
|
|
|
New flat core winding technology allows for a wirewound heatsinkable resistor affording a very low profile, and superior thermal transfer when compared to conventional aluminum housed wirewound resistors. Close mounting of heat sensitive components is possible due to only a slight rise of the temperature on the aluminum profile. No heat sink compound is required because of a large mounting surface. These 6 Ohm, 50 Watt load resistors will work on any vehicle and can be connected across the turn signal bulbs or License Plate Lights to simulate the load of a regular filament bulb (2 Amp load). This will solve LED related turn signal lights or license plate light problems such as hyper flashing, no flashing or burnt out bulb indications. One LED resistor is required for each turn signal bulb or each license plate light bulb. Note: LED Load Resistor will get hot, therefore, please don't mount the LED load resistors on plastic. 2 Pack
- (2) Pack
- Complete welded construction
- Mounts on chassis to utilize heat-sink effect
- Meets applicable requirements of MIL-PRF-18546
- Molded construction for total environmental protection
- Excellent stability in operation (<1% change in resistance)
- Resistance Tolerance: 10%, 5%, 3%, 2%, 1%, 0.5%
- Operating Temperature Range : -55% to +275°C
- Limited 90 Day Warranty
Ming's Mark Inc. 29005 6 OHM 50 Watt Load Resistor 2 Pack
|
|
|
|
|
|
|