Home > Electrical > Solar Systems >

Zamp Solar ZS-600-CPAP-PS 600 Watt Cpap Station

Zamp Solar 600 Watt Cpap Station
Zamp Solar ZS-600-CPAP-PS 600 Watt Cpap Station
 
Alternative Views:
: $683.62
MFG P/N: ZS-600-CPAP-PS
MFG: Zamp Solar
UPC #: 893684002213
Shipping: Free Shipping

Quantity in Stock :


Availability: Out of Stock
Product Code: 19-2744
Qty:

DESCRIPTION Instructions
 
Get a great night’s sleep with the Zamp Solar CPAP Power System. This system will power up to 2 standard sleep apnea machines at a time using any 12 volt battery bank available. It can be installed in any type of mobile vehicle. This kit is complete with all the necessary hardware for an easy install. Finally, a restful night’s sleep while camping or exploring.

600 Watt Cpap Station

The Zamp Solar 600 Watt Cpap Station is equipped with a main control panel that can be mounted up to 25′ away from the inverter. This main control panel also acts as a remote switch for inverter operation. The main control panel houses the AC ports, voltage readouts and the main switches for turning on and off the LED voltage readout and remotely turning on and off the inverter. In addition to the voltage readout is a battery health indicator chart located on the bottom of the main control panel face plate. Use the voltage readout to compare at what health your battery is to ensure you have the power to last the night. This main control panel can be easily surfaced or flushed mounted close to sleeping quarters for function and convenience.

The CPAP pure sine wave inverter is specially designed to give the greatest efficiency and flexibility. This inverter uses AC direct connect ports that can extend the AC outlets over long distances. Keeping the inverter close to the batteries helps increase the efficiency of the inverter while allowing the power supplied from the inverter to be used at greater distances. Our CPAP pure sine wave inverter also incorporates a remote switch options for turning the inverter on and off.
Additional Product Information
Much of the wiring needed is already done to make for an easy installation of the CPAP power system. Color coded wires and many of the wire ends have been pre-wired for their specific locations. There are only a few wires with cut ends that that need to be wired with wiring connections to. This allows greater installation flexibility. Our wire is a copper strand core and the wire size and length have been properly configured for this set up.