Home > Electronics > Seelevel Tank Monitoring System >

Garnet 709-RVC-NLP SeeLevel II 3 Tank Monitoring System with Alarm - Monitor Only
Garnet 709-RVC-NLP SeeLevel II Tank Monitoring System with Alarm - Monitor Only
Garnet 709-RVC-NLP SeeLevel II Tank Monitoring System with Alarm - Monitor Only
 
Price: $232.95
MFG P/N: 709-RVC-NLP-MO
MFG: Garnet Instruments
SHIPS: Same Business Day Before 1 PM EST

Quantity in Stock :1

Free Shipping
Availability: In Stock
Qty:

Description Instructions
 
The Garnet 709-RVC-NLP is a tank monitor that works with the Garnet 709-RVC-NLP SeeLevel II Tank Monitoring System With Alarm. It is designed for accurate level measurement of motorhomes and trailers with three holding tanks. This system monitors battery voltage, fresh, grey and black water levels. The level in percent is shown on a three-digit LED display. This model includes an RV-C network interface and a common alarm output which is programmable for level and polarity.
  • Works with Garnet 709-RVC-NLP SeeLevel II Tank Monitoring System with Alarm.
  • Purchase as a second console to be installed outside by the holding tanks
  • Provides accurate tank level information using a percentage of full readout.
  • Uses common industry connector for ease of installation and servicing.
  • RV-C CAN bus interface allows continuous communication with other RV-C compatible systems such as Silver Leaf and Firefly.
  • Alarm output for controlling warning devices, shutoffs, etc.
    • Any or all of the tanks can control the alarm.
  • Continuous scanning of tank levels ensures that the alarm and RV-C interface is always current.
  • The display requires 12 volts from the RV battery, the system will function from 11 volts to 16 volts.
  • Current drain is less than 200mA.
  • Panel Dimensions: 4" W x 2.8" H x 1" D.
    • Required Cutout Size: 3" W x 1.8" H.
  • Includes (1) SeeLevel 709-RVC-NLP monitor and connector assembly/pigtail
  • Limited 1-year manufacturer warranty.

Garnet 709-RVC-NLP SeeLevel II Tank Monitoring System with Alarm - Monitor Only

Additional Product Information
Display mounting panel: Black panel, approximately 4” wide by 2.8” high by 1” thick (102mm wide X 71mm high X 25mm deep). Panel screws to wall.

Power requirements: Display requires 12 volts from the RV battery, the system will function from 11 volts to 16 volts. Current drain is less than 200mA.

Wiring: A single two wire conductor required from the display to the senders. All the senders are wired in parallel. 12 V power and ground required for display. Single wire required for LPG sender if sender grounded at tank.

LPG sender: Display will work with an LPG sender resistance of 0-50 ohms to 0-500 ohms. Display shows increasing level as resistance increases. System must be calibrated with the LPG tank full.

ACCESSORIES
Garnet 710-SS SeeLevel Sender Board - 16" Garnet 709-RVC-PM SeeLevel II 3 Tank Monitor with Alarm - Monitor Only Garnet 709-gasket SeeLevel 709 Gasket Garnet 709-filler SeeLevel 709 Filler Plate
Price: $59.95

Add
Price: $232.95

Add Free Shipping
Price: $10.25

Add
Price: $10.25

Add
Garnet 710SS SeeLevel II Sensor Board - 16" Garnet 709-RVC-PM SeeLevel II Tank Monitor with Alarm - Monitor Only Garnet 709-gasket SeeLevel 709 Gasket Garnet 709-filler SeeLevel 709 Filler Plate