Garnet 709-4 SeeLevel (4) RV Tank Monitoring System

Garnet 709-4 SeeLevel II Tank Monitoring System

Garnet SeeLevel II Tank Monitoring System

Alternative Views:

: $352.07

MFG P/N: 709-4_System
MFG: Garnet Instruments

SHIPS: In 1 Business Day
NOTE: Ships From Eastlake, Oh

Quantity in Stock :19

Availability: In Stock

Select Tank Sensor Sizes

Fresh Water Tank*:

Grey Water Tank*:

Black Water Tank*:

Galley Tank*:

Qty:

Description

The SeeLevel 709-4 Tank Monitoring System is designed to accurately display fluid levels in a motorhome or camper with four holding tanks. This system monitors battery voltage, fresh, grey, galley and black water levels. The level in percent is shown on a three digit LED display.

709-4 System Monitors:
battery voltage
fresh water tank
grey water tank
black water tank
galley tank
Provides accurate tank level information using percentage of full readout
Tanks are monitored using Garnet’s proprietary external level sensing technology
- This ends fouling problems caused by debris build-up in the holding tank
- Detailed diagnostic information monitors sender operation
Tank senders connect to the display via a common bus network
- All senders can be connected using the same wire
Three different sender sizes available to fit your tanks
- 710-AR2 Sender:
  - Dimensions: 9" high x 2.2" wide
  - Resolution: .25" Segments
  - Measurable range: 3" to 9"
  - Tank heights from 3.5" to 10.5" (single sensor)
  - Up to 19.5" (dual stacked sensors).
- 710-ES3 Sender:
  - Dimensions 12.15” high x 2.2” wide
  - Resolution: .33" Segments
  - Measurable range: 4" to 12"
  - Tank heights from 4.5" to 14" (single sensor)
  - Up to 26” (dual stacked sensors)
- 710-SS2 Sender:
  - Dimensions 16" high x 2" wide
  - Resolution: .44" Segments
  - Measurable range: 6" to 16"
  - Tank heights from 7" to 18" (single sensor)
  - Up to 34.5” (dual stacked sensors).
Sensors only work on plastic/polyethylene and fiberglass tanks
Uses common industry connector for ease of installation and servicing
Display requires 12 volts from the RV battery, the system will function from 11 volts to 16 volts
Current drain is less than 200mA
Panel Dimensions: 4" W x 2.8" H x 1" D
- Required Cutout Size: 3" W x 1.8" H
Includes:
- (1) Display monitor.
- (1) pigtail
- (4) mounting screws.
- (4) tank sensors
Senders will not work on metal tanks.
Limited 1 year manufacturer warranty
See our SeeLevel Tank Monitor Comparison Guide to help you choose the right system for your RV.

Garnet 709-4 SeeLevel II Tank Monitoring System

Garnet SeeLevel Tank Monitor Resource Library

Display Mounting Panel: Black flush mount panel, approximately 4” wide by 2.8” high by 1” deep (102mm wide X 71mm high X 25mm deep). Panel screws to wall. Required cutout size is 3” wide by 1.8” high.

System Power Requirements: Display requires 12 volts from the RV battery, the system will function from 11 volts to 16 volts. Current drain is less than 200mA.

Wiring: A single two wire conductor required from the display to the senders. All the senders are wired in parallel. 12 V power and ground required for display. Single wire required for LPG sender if sender grounded at tank.