|
|
|
|
The SeeLevel 709-P3W Tank Monitoring System is designed for accurate level measurement of motorhomes and trailers with three holding tanks. This system monitors battery voltage, fresh, grey, and black water levels as well as the LPG tank. The level in percent is shown on a three digit LED display. This model includes a 3-way pump switch with connector which allows for more wiring options.
- Monitors: battery voltage, fresh water tank, grey water tank, black water tank and LPG tank
- Includes Fresh Water Pump Switch
- Also Provides accurate tank level information using percentage of full readout
- Tanks are monitored using Garnet’s proprietary external level sensing technology
- This ends fouling problems caused by debris build-up in the holding tank
- Detailed diagnostic information monitors sender operation
- Measures tanks from 3" up to 34" depending on the sensors you specify
- Tank senders connect to display via a common bus network topology which saves wiring costs
- LPG tank connection compatible with existing electric senders
- Calibrate LPG at first fill of tank or it can be factory calibrated
- Uses common industry connector for ease of installation and servicing
- Display requires 12 volts from the RV battery, the system will function from 11 volts to 16 volts
- Current drain is less than 200mA
- Panel Dimensions: 4" W x 2.8" H x 1" D
- Required Cutout Size: 3" W x 1.8" H
- Includes: (1) Display monitor, (3) 9″ 710-AR tank senders, (1) pigtail and mounting screws
- Limited 1 year manufacturer warranty
- Also Know by p/n# 709P3W1003 or 709-P3W-1003
- See our SeeLevel Tank Monitor Comparison Guide to help you choose the right system for your RV.
Garnet 709-P3W SeeLevel Tank Monitoring System
Seelevel 709-P3W Tank Monitoring System
Seelevel Sensor Installation
|
|
|
|
|
|
|
|
|
|
|
|
|
Additional Product Information
Display Mounting Panel: Black flush mount panel, approximately 4” wide by 2.8” high by 1” deep (102mm wide X 71mm high X 25mm deep). Panel screws to wall. Required cutout size is 3” wide by 1.8” high.
System Power Requirements: Display requires 12 volts from the RV battery, the system will function from 11 volts to 16 volts. Current drain is less than 200mA.
Wiring: A single two wire conductor required from the display to the senders. All the senders are wired in parallel. 12 V power and ground required for display. Single wire required for LPG sender if sender grounded at tank.
LPG: Display will work with an LPG sender with a maximum resistance of 50 ohms to 500 ohms. Display shows increasing level as resistance increases. System must be calibrated with the LPG tank full, or it can be factory calibrated.
Pump Switch: The pump switch is rated for a maximum of 10 amps. The use of a relay is required if more than 10 amps is needed. We recommend using a 10 amp fuse inline with the switch.
|
|
|
|
|
|
|