Keep your RV's propane supply protected between trips. The ADCO 2114 is a purpose-built, weatherproof cover sized for two standard 40 lb (10-gallon) propane cylinders. Heavy-duty polar white vinyl resists sun, rain, and road grime while the molded nylon zipper lets you access tank valves without removing the cover.
Propane tanks left exposed deteriorate faster -- UV rays fade valve markings, moisture accelerates rust on the collar and foot ring, and road debris can damage regulators. ADCO's tank covers are one of the simplest, most cost-effective ways to extend tank life and maintain a clean, finished look on your RV exterior.
The ADCO 2114 is designed specifically for the most common large-cylinder setup on fifth wheels, travel trailers, and motorhomes: a side-by-side pair of 40 lb (10-gallon, approximately 20 lb tare weight) DOT cylinders. The cover slips over both tanks as a single unit, keeping them paired and tidy during storage or travel.
Heavy-duty vinyl construction resists UV fading, cracking, and moisture -- purpose-built for outdoor RV storage conditions year-round.
Full-length zipper runs down the front panel for quick access to tank valves and regulators without removing the entire cover.
Hollow bead welt cord along the hem and an elastic shock cord work together to create a snug, rattle-free fit that stays put at highway speeds.
Neutral polar white color coordinates with most RV exterior color schemes and reflects heat to help keep tanks cooler in direct sunlight.
ADCO uses a hollow bead welt cord sewn into the lower hem of the cover. This cord gives the material structure and prevents the hem from rolling or flapping. The elastic shock cord threaded through the bottom hem cinches the cover tightly under the tank bases, keeping it secure even in windy conditions or when driving.
The molded nylon zipper is more durable than standard fabric-tape zippers commonly found on generic covers. Nylon molded teeth resist corrosion and are easier to operate with cold or gloved hands -- a practical detail if you are winterizing in late fall.
The cover is suitable for both active travel and long-term storage. The vinyl shell blocks UV radiation and precipitation, while the fitted lower hem prevents moisture pooling. During storage, leaving tanks covered helps prevent valve corrosion and keeps spiders and insects from nesting around regulator fittings -- a common cause of gas flow problems on rigs that sit for extended periods.
ADCO backs this cover with a limited 3-year manufacturer warranty against defects in materials and workmanship. The cover is sold individually -- one cover fits two 40 lb cylinders as a set. No mounting hardware or brackets are included; the cover relies on its elastic shock cord and bead welt hem for retention.