Stop living with a cracked, leaking, or beat-up water fill fitting. The Aqua-Pro 27869 is a clean, low-profile flush-mount fresh water inlet designed to sit flush against your RV sidewall -- no bulky housing sticking out, no sloppy fit. At just 3.5 x 3.5 inches face diameter and under a quarter pound, it installs quickly and looks factory-clean on any Class A, Class C, fifth wheel, or travel trailer.
The Aqua-Pro 27869 replaces your RV's fresh water fill port with a flush-mount design that sits level with the sidewall panel. That means no protruding housing to snag on brush at the campsite, no gap where road grime collects, and a much cleaner finished look compared to surface-mount or recessed barrel-style inlets.
This fitting is designed for the fresh water fill port -- the connection where you top off your onboard tank from a campground spigot or hose at home. It is not a city water inlet (that is a separate pressurized connection). The fill port flows through to your fresh water holding tank by gravity or low-pressure hand pump.
Sits level with the RV sidewall. No protruding housing to catch dirt, debris, or damage at the campsite.
3.5 x 3.5 inch face and only 3.25 inches deep. Fits tight sidewall cavities where oversized housings will not clear.
Only 0.3 lbs. Adds virtually no weight to the RV sidewall panel and does not require additional reinforcement.
Sized and shaped to replace common OEM-style flush-mount water fill fittings on travel trailers, fifth wheels, and motorhomes.
Your RV has two separate water connections on the exterior: the city water inlet (pressurized, typically a standard garden-hose fitting) and the fresh water tank fill port (gravity-fed, used to fill the onboard tank). The Aqua-Pro 27869 is the tank fill fitting -- the one you open with a hose when you want to top off your fresh water supply before heading out.
Over time these fittings crack from UV exposure, freeze/thaw cycles, or simply get broken by a hose fitting torqued in at the wrong angle. A cracked housing can allow road spray and insects into the sidewall cavity. Replacing it is a straightforward job that keeps your water supply clean and your sidewall sealed.
Replacing an existing flush-mount water fill fitting is typically a one-tool job:
The Aqua-Pro 27869 is suited for fresh water tank fill applications on a wide range of RV types:
Before ordering, confirm your existing cutout opening is compatible with the 3.5 x 3.5 inch face plate. If your current fitting uses a larger or smaller panel opening, minor trimming or a backing plate may be needed.