Blue Streak THETFORD AQUA-MAGIC GALAXY / STARLITE Installation



INSTALLATION INSTRUCTIONS
THETFORD AQUA-MAGIC® GALAXY / STARLITE

1. Remove the stool to access the back.

A. Remove two bolts, one in the front by the pedal and one in the rear ( or the plug located at the top of the stool ).
B. Remove the water line located at the rear of the stool.
( MAKE SURE WATER IS OFF )

2. Locate flush line between vacuum breaker and bowl.

A. Cut line half way between the two.

B. Insert T-valve with small arrow pointing towards bowl.
( THIS IS VERY IMPORTANT )

C. With the two hose clamps enclosed in kit, secure T- valve in place.
(Photo View 1)

Click here for full diagram of assembly & Parts


View 1

3. Reinstall stool making sure all gaskets,
bolts and water connections are secure.
4. Mounting the dispenser reservoir to the wall.

A. Locate reservoir to the back or side of the wall providing easy access for filling.
B. Keep level or lower than back of stool.
C. Screw reservoir into place with the three screws provided with kit.

5. FINAL CHECK LIST
A. Check water line for leaks.
B. Check stool by flushing.
C. Add a few ounces of
Blue Streak Chemical® to reservoir.
D. Flush stool. Finish filling reservoir.
6. Q: How Do I Winterize the Blue Streak Dispenser?

A: Run the chemical level low [1to 2 inches] in the reservoir and winterize your unit as you would normally. To remove chemical from the reservoir; unscrew the tank from the wall leaving tubing attached to tank and pour chemical into another container.