OEM replacement gear box with mounting bracket for BAL R25076 12V Accu-Slide cable-driven room systems. 13-tooth sprocket. Compatible with motor assemblies R25074, R25075, and R25076. Sold as one unit.
The BAL 25076-1 is the OEM service replacement gear box for the R25076 12-volt Accu-Slide cable-driven slide-out system. It is the direct replacement for a worn or failed gear box in any RV equipped with the BAL Accu-Slide cable-driven room system, covering 5th wheels, travel trailers, and motorhomes that use this platform.
The gear box comes with a mounting bracket pre-installed, simplifying the swap — remove the old unit, bolt the new one in its place, realign the chain tensioners, and the slide room is back in service. It is compatible with all current BAL Accu-Slide motor assemblies including both standard and high-torque variants.
Per BAL's own product page, the 25076-1 gear box is compatible with the following motor assemblies: • 225007 — Sprocket Up Assembly 64ZY (NTP part number) • 225008 — Sprocket Up Assembly 68ZY (NTP part number) • 21900000 — Sprocket Up Assembly 64ZY Standard Torque • 21900001 — Sprocket Down Assembly 64ZY Standard Torque • 21900002 — Sprocket Up Assembly 68ZY High Torque • 21900003 — Sprocket Down Assembly 68ZY High Torque Also cross-references motor part numbers R25074 and R25075.
• 1x BAL 25076-1 Replacement Gear Box • 1x Mounting Bracket (pre-installed) Motor assembly sold separately if also needed: • R25075 / 225008 — BAL Accu-Slide replacement motor
The 25076-1 is specifically for the R25076 cable-driven Accu-Slide system. BAL produces several slide-out system variants. Before ordering, confirm your system uses the R25076 cable-driven platform by checking the label on your existing motor/gear box assembly or your RV's service manual. This part is not compatible with rack-and-pinion or in-wall slide-out systems.