Add trailer lighting capability to your 2011-2013 Mitsubishi Outlander or 2012-2013 Outlander Sport without cutting a single wire. CURT part 56127 is a vehicle-specific T-one connector harness that taps directly into your factory tail light wiring, delivering a clean, reliable 4-pin flat connection at the rear of the vehicle.
Generic wiring kits require you to cut into your vehicle's tail light circuits, risking shorts, blown fuses, and voided warranties. The CURT 56127 uses a T-one converter design that plugs inline with the factory tail light connectors -- no splicing, no soldering, no guesswork. The harness routes neatly to a standard 4-pin flat trailer connector that hangs at the hitch receiver ready to plug into any standard trailer or bike rack lighting system.
CURT engineered this harness specifically around the 2011-2013 Mitsubishi Outlander and 2012-2013 Outlander Sport tail light wiring architecture. The plug locations, wire lengths, and routing path are all matched to these vehicles, so installation is straightforward even for a first-timer with basic hand tools.
Plugs inline with factory tail light harness connectors. No wire cutting or soldering required for a clean, reversible install.
Standard 4-pin flat trailer connector provides running lights, brake lights, and turn signals to any compatible trailer, bike rack, or cargo carrier.
Custom-molded connectors match the exact Mitsubishi Outlander tail light plugs -- no adapters needed, no rattling loose over time.
Built-in converter handles vehicles that use a combined brake/turn signal circuit and translates it to the separate brake and turn signal wires trailers require.
The 4-pin flat connector on the CURT 56127 carries the four standard trailer lighting functions:
This covers the legal lighting requirements for most open utility trailers, boat trailers, small enclosed trailers, folding camping trailers, bike racks with lighting boards, and cargo carriers with lights. It does not carry electric brake output or auxiliary 12V power -- those require a separate brake controller and 7-pin connector system.
CURT's T-one connector harnesses (the 5-digit part numbers in the 56000 range) are vehicle-specific plug-and-play solutions. They sit above universal splice-in kits in terms of installation ease and below CURT's powered 5-pin and 7-pin converter harnesses in terms of trailer capability. The 56127 is the correct T-one harness for these specific Mitsubishi model years -- other Outlander years use different part numbers due to tail light connector changes.