Home > Jacks & Levelers > Levelers >

Camco 44521 FasTen RV Leveling Blocks with T-Handle 2x2 10-Pack Brown

Camco 44521 FasTen RV Leveling Blocks 2x2 10-Pack Brown interlocking blocks with T-handle for stacking and storage
Camco FasTen RV Leveling Blocks with T-Handle, 2x2, 10-Pack, Brown
 
Alternative Views:


List Price: $71.89
: $55.49
You save $16.40!
Part Number: 44521
Manufacturer: Camco

Quantity in Stock :19

Availability: In Stock
Qty:

 
Camco Part 44521 10-Pack FasTen RV Leveling Blocks with T-Handle -- 2x2, Brown

Solid, interlocking leveling blocks designed for RVs, campers, trailers, and tow vehicles. Stack them to the height you need, then lock the stack together with the included T-handle for no-fumble carry and compact storage.

Get Level Anywhere -- Without the Guesswork

Finding a perfectly level campsite is rarely a given. The Camco 44521 FasTen Leveling Blocks let you build a custom platform under your RV tires or stabilizer jacks in seconds. The 2x2 interlocking design means blocks snap together firmly -- no sliding, no shifting as you pull forward or back onto the stack.

Each block in the set contributes approximately 1 inch of lift. With 10 blocks per pack you can split the set across multiple tires or run a taller stack under a single wheel. Camco recommends keeping any single stack at or below 4.5 inches to maintain safe, stable support.

Interlocking 2x2 Design

Blocks snap together in a 2x2 pattern for a wide, stable base that resists shifting under load.

~1 Inch Per Block

Dial in precise leveling height one block at a time. Max recommended single-stack height: 4.5 inches.

Included T-Handle

Pulls up for easy carrying. Twist it down to lock the stack together for neat, compact storage.

10 Blocks Per Pack

Enough blocks to level both drive-side and passenger-side wheels at the same time, or build a taller single stack.

Why Interlocking Blocks Beat Loose Boards

Traditional boards and wedge ramps can creep, split, or tip when a tire rolls onto them at an angle. The FasTen snap-together matrix keeps the platform rigid while you position the rig -- and stays put once you are parked. The wide 2x2 footprint spreads load across soft ground better than a single narrow board.

T-Handle Storage System

The T-handle is more than a carrying grip. Twist it clockwise to lock the assembled stack solid, so the whole set travels as one unit in your basement storage or cargo bay. No loose blocks rattling around, no missing pieces at your next site.

Common Uses

  • Leveling motorhomes, fifth wheels, and travel trailers under drive axle or tag axle tires
  • Providing a firm base under stabilizer jack feet on soft or uneven ground
  • Leveling a tow vehicle when unhitched on a sloped driveway or staging area
  • Chocking or shimming when used in combination with a separate wheel chock (chocks sold separately)

Setup and Care Tips

  • Position the block stack in front of or behind the low-side tire before pulling forward or backing up -- never build the stack under a loaded tire.
  • Inspect blocks before each use for cracks, warping, or broken snap tabs. Damaged blocks should be replaced before use.
  • Rinse with water after muddy or sandy use. The polypropylene surface resists fuel and oil spotting but prolonged chemical exposure can weaken the plastic.
  • Store the locked stack out of direct UV exposure when not in use to extend service life.

Product Specifications

ManufacturerCamco
Part Number44521
Vendor Part Number15-1446
UPC014717445214
ColorBrown
Pack Quantity10 blocks + 1 T-handle

Block Dimensions and Performance

Block Pattern2x2 interlocking grid
Height Per Block (approx.)1 inch
Max Recommended Stack Height4.5 inches
MaterialPolypropylene plastic

What's in the Box

Leveling Blocks10 interlocking 2x2 blocks
T-Handle1 included -- carries and locks stack
Wheel ChocksNot included
Bag or CaseNot included

Compatibility

Vehicle TypesMotorhomes, fifth wheels, travel trailers, toy haulers, pop-up campers, tow vehicles
Compatible BlocksSnaps with other Camco FasTen 2x2 interlocking leveling block sets for added height or wider base
Chock CompatibilityUse with Camco FasTen wheel chocks (sold separately) for a complete leveling and chocking system

Important Information

  • Maximum recommended single-stack height is 4.5 inches (approximately 4-5 blocks). Exceeding this height increases the risk of the stack tipping or collapsing under load.
  • Never drive onto or build a stack under a tire that is already bearing full vehicle weight. Always position blocks on open ground first, then roll the tire onto the stack slowly.
  • These blocks are designed for leveling support of parked RVs and vehicles -- they are not rated as jack stands and must not be used to support a vehicle during tire changes or undercarriage work.
  • Inspect all blocks for cracks or broken interlocking tabs before each use. Do not use damaged blocks.
  • Wheel chocks are not included. Camco recommends using wheel chocks in combination with leveling blocks to prevent unintended movement.
  • Prolonged exposure to sunlight and outdoor elements will gradually degrade polypropylene. Replace blocks that show significant cracking, discoloration, or deformation.


Browse for more RV Accessories in the same category as this item:

Jacks & Levelers > Levelers
Jacks & Levelers