Pre-cut door window shade for RV entry doors. Blocks light and sun, reduces interior heat gain, and adds privacy. Black nylon ripstop outer with silver reflective backing. Nine hook-and-loop fasteners included for tool-free installation. Single shade.
The Camco 45148 is a pre-cut light blocking shade sized for the window in a standard RV entry door. At 25-1/4" x 16-1/4", it covers the typical rectangular door window without trimming, and the two-layer construction — black nylon ripstop on the exterior face, silver reflective material on the interior face — handles both light blocking and heat rejection simultaneously. The black outer face absorbs and dissipates solar energy while the silver reflective backing reflects radiant heat away from the interior.
Nine hook-and-loop fasteners (1" x 1-1/2" each) are included for installation — press one side of each fastener onto the window frame and the other onto the shade perimeter, and the shade mounts and removes in seconds with no tools and no permanent modifications. Beyond the door window, it can also be used on other small RV windows where privacy or solar blocking is needed.
Tool-free hook-and-loop installation: 1. Clean the window frame surface where fasteners will attach — remove dust, oil, or residue for best adhesion 2. Peel the adhesive backing from one side of each hook-and-loop fastener and press onto the window frame at even intervals around the perimeter 3. Press the mating fastener halves onto the corresponding positions on the shade 4. Press the shade onto the frame-mounted fasteners to install — peel away to remove Tip: If the shade will be used frequently, consider also running a strip of hook-and-loop tape along the full top and bottom edges rather than relying solely on the nine individual fasteners.
• 1x Camco 45148 Door Window Shade (25-1/4" x 16-1/4") • 9x Hook-and-loop fasteners (1" x 1-1/2" each) Need larger coverage? • 45162 — Camco SunShield Reflective Window Cover, 50" x 30" • 45167 — Camco SunShield Door Window Cover, 16" x 24"
The 45148 is pre-cut to 25-1/4" x 16-1/4". Most standard RV entry door windows fall within this size, but not all. Measure your door window opening before ordering to confirm this shade will cover it without trimming. If your window is larger, see the 45162 (50" x 30") or cut a larger shade material to fit.