When your 30 amp RV cord needs to reach a standard household outlet, the Camco 55222 Power Grip adapter closes that gap. A 5-15P male plug on one side and a TT-30R female receptacle on the other give you a clean, direct connection -- no dongles, no extension cord hacks. The molded grip handle makes plugging in and pulling out easier on your hands, your outlet, and your cord end.
Most garages, driveways, and storage sites only have standard 15 amp household receptacles. That does not mean your 30 amp RV is out of luck. The Camco 55222 lets you connect your existing 30 amp shore power cord to those outlets so you can keep your battery bank charged, run your refrigerator in propane-electric mode, operate your roof vent fans, or power a few interior lights -- all without running an extension cord to a different outlet or rewiring anything.
This is not a high-draw solution. You are limited to 15 amps of available current at 125 volts -- roughly 1,875 watts maximum. Air conditioners, electric water heaters, and microwave ovens draw far more than that and will trip the household breaker. Think of this adapter as a maintenance and light-use tool, not a full campground power replacement.
Standard 3-prong 15 amp household plug fits any NEMA 5-15R outlet -- the same receptacle found in virtually every garage, shop, and driveway in North America.
The female end accepts the standard TT-30P plug found on most 30 amp RV shore power cords. No inline adapter or pigtail needed.
The molded ergonomic body gives you a real handhold for plugging and unplugging -- reducing wear on the outlet and cord and making the task easier in cold weather or wet conditions.
The adapter is a single molded unit with no moving parts or detachable pieces. Toss it in your power kit, tool bag, or basement bay without worry.
The 55222 uses Camco's Power Grip molded housing construction -- the same platform used across Camco's adapter lineup. The body is formed as a single piece with the plug and receptacle fully integrated, so there are no weak joints where a two-piece design might separate under repeated use. The grip profile is shaped to fit a gloved hand, which matters when you are working at a cold outlet in a dark storage bay.