Keep your Freedom awning roller tube sealed and protected. This genuine Carefree of Colorado replacement end cap blocks moisture, UV rays, and road debris from entering the open end of the roller tube on the right-hand side of your Freedom wall-mount awning. A small part that prevents big repairs.
The roller tube end cap is one of those components you never think about -- until it cracks, goes missing, or lets water into the tube. Once moisture gets inside the roller tube, it can accelerate fabric wear, cause corrosion on internal hardware, and lead to costly awning repairs down the road. The Carefree R001623 replaces the right-hand end cap on Freedom series wall-mount awnings with an OEM-quality part built to the same spec as the original.
This cap screws securely into place using the existing mounting holes at the end of the roller tube. Installation hardware is included, so no special tools or adapters are needed. The UV-resistant construction resists fading and cracking even after seasons of sun exposure -- a common failure point on older plastic end caps.
Creates a tight seal at the roller tube end, blocking rain and road moisture from entering and damaging internal awning components.
Formulated to resist cracking and fading from prolonged sun exposure, extending service life compared to older-generation plastic caps.
Mounting screws are included in the package. No separate fastener kit required for a straightforward drop-in replacement.
Genuine Carefree of Colorado part. Designed specifically for the Freedom wall-mount awning roller tube -- not a universal adapter.
Over time, original end caps can crack from UV exposure, become brittle in cold climates, or simply go missing during awning service. Replacing a damaged cap is far less expensive than addressing the water damage or fabric wear that results from leaving the tube end open. This part is a direct OEM replacement for the right-hand side of the Freedom roller tube.
Installation is straightforward for anyone comfortable with basic hand tools. The cap seats into the right-hand end of the roller tube and secures with the included screws. No drilling or modification of the tube is required on a direct replacement -- the existing screw holes are reused.