NBK Complete Draft Inducer Assembly – Replaces Carrier 326628-762 (Also Replaces Packard 66762)

This is the complete inducer assembly (as pictured): aluminum housing/scroll with the factory-installed blower wheel, a 2-speed 115V motor, mounting bracket with isolation grommets, and pre-wired leads. It’s a direct replacement for inducer assemblies that use Carrier 326628-762 motor and crosses to Packard 66762. Drop-in swap—no wheel puller, no fighting set screws.

Why choose the complete assembly

• Easiest install: Wheel is already mounted and balanced—no transfer from the old motor.
• Correct geometry: Outlet orientation and pressure-port alignment match the OEM assembly.
• Less downtime: Swap the module, wire it, verify draft/pressure-switch close—done.

Dimensions & envelope

• Motor frame: 3.3" (42-frame class) inside the scroll.
• Motor: 1.04/0.28 amps, 115 Volts
• Thermally Protected
• C-Frame Style Motor
• Ball Bearing
• Blower Wheel: 3.8" x 1.6"
• Includes New Gasket
• Rotation: CW Shaft End
• Overall envelope: Matches OEM inducer footprint; allow space for the rear motor cap and front outlet.
• Outlet orientation: Same as OEM for the 326628-762 application (verify against your housing).

What’s in the box

• Inducer housing/scroll with pre-installed blower wheel
• 2-speed 115V motor (High ≈ 2990 RPM / Low ≈ 1318 RPM)
• Mounting bracket & isolation grommets
• Pre-wired leads (High/Low/Neutral/Ground ring)
• Re-use OEM gasket or replace if deteriorated

Installation tips

1. Disconnect power & gas. Remove the old inducer as a unit.
2. Transfer any brackets/duct seals as needed. Mount new assembly.
3. Connect High/Low speed leads as per your furnace diagram; connect Neutral and chassis Ground.
4. Run a heat cycle; verify pressure-switch operation and quiet, rub-free rotation.

Warranty & support

• NBK limited manufacturer warranty (terms apply)
• RVupgrades phone, chat, email & text support