Replacement bolt pack for Fastway e2 weight distribution hitch systems. This hardware kit is used to secure the e2 hitch head assembly to the adjustable shank and works with both e2 round bar and trunnion bar weight distribution hitch systems.
The Fastway 92-02-9600 e2 Bolt Pack is a genuine replacement hardware kit for Fastway e2 weight distribution hitch head assemblies. It is used when installing, servicing, or replacing the hardware that connects the e2 hitch head to the adjustable shank.
This kit is compatible with both Fastway e2 round bar and trunnion bar weight distribution hitch systems. It is useful when original hitch head hardware is missing, worn, damaged, corroded, or being replaced during hitch service.
Replacement bolt pack for Fastway e2 weight distribution hitch systems
Works with Fastway e2 round bar and trunnion bar hitch setups
Used to secure the e2 hitch head assembly to the adjustable shank
Useful for replacing worn, damaged, missing, or corroded hitch head hardware
Weight distribution hitch hardware is load-bearing. Always use the correct Fastway e2 hardware and follow the torque specifications in the Fastway e2 owner's manual when attaching the hitch head to the adjustable shank. Confirm the hitch head, shank, spacer setup, and hardware are installed in the correct order for your specific e2 round bar or trunnion bar system before towing.
Replace hitch head hardware if any pieces are missing, damaged, heavily corroded, distorted, stripped, cross-threaded, or no longer able to torque properly. During hitch service: Replace questionable hardware whenever the hitch head is removed, serviced, or reconfigured. After visible damage: Do not reuse hardware that is bent, cracked, stripped, stretched, or visibly deformed. After corrosion: Heavy rust can weaken hardware and make correct torque difficult to achieve. During used-hitch setup: A replacement bolt pack is helpful when setting up a used e2 hitch with incomplete or questionable original hardware.
Installation Steps: 1. Park Safely: Park the tow vehicle and trailer on level ground before servicing the hitch 2. Inspect Existing Hardware: Check the hitch head connection hardware for wear, damage, corrosion, or missing pieces 3. Position the Hitch Head: Place the Fastway e2 hitch head on the adjustable shank at the correct height for the trailer setup 4. Set Hitch Head Angle: Configure the spacer setup according to the e2 owner's manual 5. Secure the Hitch Head: Install the hitch head hardware in the correct order and orientation 6. Torque to Specification: Tighten all hitch head hardware to the torque value specified in the Fastway e2 owner's manual 7. Final Safety Check: Confirm the hitch head, shank, hitch pin, spring arms, and trailer brackets are properly secured before towing Always follow the Fastway e2 owner's manual for your specific hitch model. Do not tow with missing, damaged, modified, or improperly torqued weight distribution hitch hardware.
• (2) 3/4-10 x 5" Grade 5 Bolts • (4) 3/4" Conical-Toothed Washers • (2) 3/4" Nylock Nuts • (1) Hitch Pin • (1) Hitch Pin Clip • (1) Spacer Rivet • (7) Spacer Washers / 1/2" Flat Spacer Washers
Fastway Trailer Products / Progress Mfg.: Website: fastwaytrailer.com/contact-us Fastway is manufactured by Progress Mfg., the same company behind Fastway and Equal-i-zer towing products.