Replacement power cable for Furrion Vision 1, Vision 2, and Vision S camera system monitors. Plugs into a standard 12V automotive (cigarette lighter) outlet. Approximately 6 feet long with auxiliary pigtail port. Marine approved. Not compatible with Vision S+.
The Furrion C-FOS07TAPK-006 is the replacement power cable for Furrion Vision 1, Vision 2, and Vision S camera system monitors — the cable that runs from a 12V automotive outlet (cigarette lighter port) in the tow vehicle or RV to the monitor, keeping the display powered during use. When the original cable is lost, damaged, or frayed, this direct replacement restores monitor power without any wiring modifications.
The cable is approximately 6 feet long, providing generous reach for flexible monitor placement on the dashboard or windshield. One end plugs into the vehicle's 12V automotive outlet; the other connects to the monitor. An auxiliary pigtail is also present on the cable, which can be used to power an additional accessory with a matching connector. Marine approved. Prop 65 warning applies.
• 1x Monitor power cable (~6 ft) with 12V automotive plug and auxiliary pigtail Monitor and camera system not included — this is the power cable only.
If your tow vehicle doesn't have a convenient 12V cigarette lighter outlet near the mounting position: • The cable's cigarette lighter plug can be cut off and the two wires connected directly to a 12V source (such as the vehicle battery) — use 16-gauge wire to extend the run if needed • A 12V outlet kit can be added to the vehicle or RV to provide a new outlet at the desired location Note: this cable uses a cigarette lighter style plug. USB or USB-C adapters are available from third parties if you prefer to power the monitor from a USB port, but those are not Furrion OEM products.
• C-FOS07TAPK-006 (this item) — Monitor power cable, 12V cigarette lighter plug (Vision 1, 2, S) • C-FOS07TAPK-007 — Camera power cable (for doorway/entry cameras) • C-FOS48TA-CIGADPT — Monitor cigarette cable with pigtail (combines monitor power and camera connection) For Vision S+ monitors (FOS7HTAPM, FOS7HTAEN, FOS7HTASF), a different power cable is required — this C-FOS07TAPK-006 is for Vision 1, 2, and S only.
This product can expose you to chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, visit www.P65Warnings.ca.gov.