When your Girard tankless water heater stops igniting or loses consistent hot water output, a failed blower motor is often the cause. This genuine OEM assembly restores proper combustion airflow so your 2GWH-32 unit runs reliably again -- no fabrication, no adapting, no guesswork.
The Girard 2022107592 is a genuine factory replacement blower motor assembly engineered specifically for the 2GWH-32 on-demand tankless water heater. The blower motor is a critical component in the combustion system -- it draws in fresh air, maintains the proper air-to-fuel ratio, and ensures the burner fires safely and consistently. When the motor wears out or fails, the unit typically shuts down on a fault code or simply will not ignite.
Because this is an OEM assembly sourced through Lippert (who acquired Girard), it matches the original mounting configuration, connector pinout, and motor speed profile of the factory unit. Direct-swap installation means no wiring modifications and no bracket fabrication.
Same mounting pattern, connector, and motor spec as the factory blower -- direct swap, no modification needed.
Maintains correct air-to-fuel ratio for safe, reliable ignition on every call for hot water.
Factory part backed by Lippert -- the current manufacturer and warranty service provider for Girard water heaters.
Designed for the 2GWH-32 model only. Verify your model number before ordering.
The 2GWH-32 is a propane-fired, on-demand tankless water heater designed for RV use. It produces hot water only when called for, with no standing pilot and no tank to keep heated. The combustion blower is integral to its sealed-combustion design, drawing outside air for the burner and exhausting combustion gases -- making the blower motor one of the highest-wear components in the system.
While the water heater is open for blower motor service, it is a good time to inspect the igniter electrode, flame sensor, and LP inlet valve. Addressing related wear items in a single service visit saves time and reduces repeat disassembly.