Home > Ride Control >

Koni 8805-1018 FSD RV Front Shocks For Ford F53 Motorhome Chassis

Koni 8805-1018 FSD RV Front Shocks For Ford F53 Motorhome Chassis
Koni FSD RV Front Shocks For Ford F53 Motorhome Chassis
 
: $259.44
Part Number: 8805-1018
Manufacturer: Koni

Quantity in Stock :4

Free Shipping
Availability: In Stock
Qty:

 
Koni 8805-1018 FSD Front Shock — Ford F53 Class A Motorhome Chassis (1988–Current) & Tiffin Allegro Breeze Powerglide

Koni 8805-1018 FSD Front Shock Absorber — Ford F53 Class A Motorhome Chassis (1988–Current) & Tiffin Allegro Breeze Powerglide

Premium KONI Frequency Selective Damping (FSD) front shock for Ford F53 Class A motorhome chassis — V8 (1988–1998 and 2021+) and V10 (1998–2020). Also fits Tiffin Allegro Breeze Powerglide (2010–2012). 19.15mm eyelet upper and lower mounts. Gold metallic finish. 9.5 lbs.

Why Upgrade to Koni FSD Front Shocks for Your F53 Class A?

The Koni 8805-1018 FSD Front Shock is the front companion to the 8805-1019 rear — together forming the complete KONI FSD suspension upgrade for the Ford F53 Class A motorhome chassis. Front shock condition is the single most important factor in how a large Class A handles on the highway: worn front shocks cause steering vagueness, front-end wander, crosswind sensitivity, and the dreaded "floating" sensation that makes a large motorhome feel disconnected and unpredictable.

KONI's FSD technology at the front axle delivers what conventional shocks cannot — firm, precise front-end control when cornering, changing lanes, or encountering sudden directional demands, with the ability to automatically soften over expansion joints and rough surfaces to preserve ride comfort. The result is a coach that responds accurately to steering inputs, tracks straight in crosswinds, and inspires the driver confidence that makes long trips enjoyable rather than exhausting.

⚙️ Frequency Selective Damping (FSD)

Automatically firm for front-end control, automatically soft for comfort — eliminates front-end wander and crosswind sensitivity

🚐 Full F53 History Coverage

Covers V8 (1988–1998 and 2021+) and V10 (1998–2020) — one front shock for the complete Ford F53 Class A production span

🔇 Vibration Filter Technology

Special internal valve blocks road vibrations and noise before they reach the coach — quieter, smoother, less fatiguing long-distance travel

🛣️ Winding Road Confidence

Controlled front axle behavior and precise steering response on narrow, winding roads where a large Class A demands full driver attention

Key Features & Benefits

  • KONI FSD Technology: Frequency Selective Damping automatically adjusts — firm through corners and rapid steering inputs, soft over expansion joints and rough pavement
  • Covers Full F53 Production History: Fits F53 V8 (1988–1998), V10 (1998–2020), and the returned V8 (2021–current) — all GVWR ratings
  • Also Fits Tiffin Allegro Breeze Powerglide (2010–2012): Confirmed fitment for this Tiffin model on the Powerglide chassis in addition to the base F53
  • Eliminates Front-End Wander and Float: Dramatically improves steering precision and front-end response that worn F53 front shocks rob from the driving experience
  • Special Vibration Filter Valve: Filters out annoying road vibrations and noise before they enter the coach — less fatigue on long-haul trips
  • Improved Crosswind Stability: Firm FSD damping significantly reduces the crosswind sensitivity and lane-drift that define the F53 with worn front shocks
  • Direct OEM Replacement: Bolt-on front shock for the F53 chassis — no modifications required
  • Gold Metallic Finish
  • 19.15mm Eyelet Mounts: Upper and lower eyelet mounts for OEM-spec fitment
  • Sold Individually: Order qty 2 for a complete front axle replacement

⚠️ Before You Order — Key Notes

V8 Returned in 2021: The product description states "'88–'98 V8 and '99-up V10" but confirmed fitment from SuperSteer also covers the V8 that returned to the F53 in 2021. This shock fits all F53 engine variants and all GVWR ratings across the full production span.

Tiffin Allegro Breeze Powerglide: Fitment for the 2010–2012 Allegro Breeze is confirmed by SuperSteer's application guide for this specific shock — verify your Allegro Breeze chassis designation before ordering.

Sold Individually: One shock absorber per package. Order qty 2 for a complete front axle replacement.

Installation Instructions

⚠️ Before Installation — Critical Stroke Check: With the vehicle at proper ride height, measure the distance between the shock mounting points. Then collapse and extend the new shock fully and measure both extremes. The shock should be near the center of its stroke when installed, with at least 3" of stroke available in either direction. If this clearance is not met, do not install — the shock could break and the warranty will be voided.

  1. Unbolt the original shock and compare it to the replacement for length and mount compatibility.
  2. Install the new shock with the label and part numbering right side up.
  3. Tighten mounting bolts to the proper torque specification for your chassis.

FSD Shocks Are Self-Adjusting: Gold-colored KONI FSD shocks automatically adjust their damping — no manual adjustment is needed or possible.

Full installation instructions PDF: supersteerparts.com/content/koni-shock-install-instructions.pdf
Technical support: SuperSteer · 888-898-3281

Technical Specifications

Part Number8805-1018
BrandKONI (Distributed by SuperSteer)
TypeFSD (Frequency Selective Damping)
PositionFront
ApplicationFord F53 Class A Motorhome — All Engine Variants; Tiffin Allegro Breeze Powerglide (2010–2012)
Extended Length28.82"
Collapsed Length17.48"
Travel11.34"
Upper Mounting StyleEyelet (19.15mm)
Lower Mounting StyleEyelet (19.15mm)
FinishGold Metallic
Weight9.5 lbs. per shock
AdjustableNo (Self-Adjusting FSD)
SoldIndividually (Qty: 1)

📦 What's Included

In The Box (Qty: 1 Shock Absorber):
• KONI 8805-1018 FSD Front Shock Absorber

NOT Included:
• Mounting Hardware
• Second shock (sold individually — order qty 2 for a complete front pair)

🔗 Related KONI F53 Motorhome Shocks

KONI 8805-1019 — FSD Rear shock for Ford F53 V8/V10 (1988–current); pairs with this front for a complete F53 upgrade

KONI 9905-1029 — EVO FSD Rear shock for Ford F53 (upgraded EVO technology for larger, heavier coaches)

For a complete F53 Class A suspension upgrade, pair this front shock (8805-1018) with the matching rear (8805-1019). Replacing all four shocks delivers the most balanced improvement in steering control, stability, and overall coach composure.

📄 Support & Warranty

SuperSteer Parts Technical Support:
Website: supersteerparts.com
Phone: 888-898-3281

KONI Warranty: Please refer to KONI warranty documentation included with product or available at koni-na.com. Does not cover mounting hardware or bushings.

Chassis & Coach Fitment — KONI 8805-1018 Front Shock

The 8805-1018 fits the following chassis and coaches at the front axle position. Covers all GVWR ratings for F53 across all engine variants. Sold individually — order two for a complete front replacement.

Chassis / Coach Years Notes
Ford F53 — V8 Engine
1988–1998
Front — All GVWR Ratings; Class A Motorhome
Ford F53 — V10 Engine
1998–2020
Front — All GVWR Ratings; Class A Motorhome
Ford F53 — V8 Engine (Returned)
2021–Current
Front — All GVWR Ratings; Class A Motorhome
Tiffin Allegro Breeze (Powerglide Chassis)
2010–2012
Front — Powerglide Chassis; Verify chassis designation

⚠️ Fitment cross-referenced across SuperSteer Parts and ShockWarehouse. The product description references "'88–'98 V8 and '99-up V10" — confirmed fitment also includes the V8 engine that returned to the F53 in 2021. Always verify your specific chassis year and engine variant before ordering.



Browse for more RV Accessories in the same category as this item:

Ride Control
Ride Control > Shock Absorbers