Home > Lippert Repair Parts > Electric and Hydraulic Slide-Out Parts >

Lippert 225487 Hydraulic Interior Slide-Out Switch -- Momentary SPST -- Almond
Lippert 225487 hydraulic interior momentary switch in almond finish with 3-terminal rear connector block for RV slide-out systems
Lippert 225487 Hydraulic Interior Switch Almond
  
Alternative Views:
: $22.80
Part Number: 225487
Manufacturer: Lippert
NOTE: Ships in 5 to 7 days

Quantity in Stock :

Availability: Out of Stock
Qty:

 
Lippert Part 225487 Hydraulic Slide-Out Lippert 225487 Hydraulic Interior Switch -- Almond

A direct OEM-replacement interior switch for Lippert hydraulic slide-out systems. This momentary single-pole switch features a 3-terminal rear connector block and an almond finish designed to blend with factory RV interiors. If your existing switch is cracked, unresponsive, or intermittent, swapping in a matching Lippert part restores reliable operation without rewiring.

Control Your Slide-Out With Confidence

Lippert hydraulic slide-out systems depend on a properly functioning interior switch to send momentary signals to the pump motor and control valve. When that switch fails -- due to age, moisture intrusion, or physical damage -- slides can become unresponsive or require multiple attempts to actuate. The 225487 is the factory-matched replacement that restores crisp, single-press operation.

The almond color matches standard factory interior trim panels found in a wide range of coach brands that use Lippert hydraulic systems, so the swap is clean and invisible from the living area.

Momentary Action

Switch activates only while held -- releases the circuit the instant you let go, matching the behavior of the original Lippert hydraulic control switch.

3-Terminal Rear Connector

Three spade or pin terminals on the back of the switch body connect directly to the existing wiring harness -- no splicing or adapter needed in most installs.

Almond Finish

Factory-matched almond color blends with standard RV interior trim panels. No painting or modification required for a factory-look replacement.

OEM Lippert Part

Sourced directly from Lippert Components, ensuring correct fit and electrical ratings for Lippert hydraulic slide-out applications.

What This Switch Does

In a Lippert hydraulic slide-out system, the interior switch sends a momentary low-current signal to the slide control board or relay, which then commands the hydraulic pump and directional valve. The switch itself does not carry motor load current -- it is a signal-level device. This means a worn or corroded switch contact causes erratic behavior out of proportion to its size, and replacement is often the fastest diagnostic step when a slide stops responding reliably.

Direct Plug-In Replacement: The 225487 is designed to drop into the existing switch cutout and connect to the factory wiring harness. In most installations no additional hardware, adapters, or wiring changes are required.

Identifying the Right Switch

Before ordering, confirm your current Lippert interior switch carries part number 225487 or is physically identical (momentary action, 3 terminals on the rear). Lippert also produces slide switches in other colors (white, for example) and in rocker configurations for different control panel layouts. Match the part number or compare terminal count and switch action to ensure compatibility.

Color Note: This listing is for the almond finish only. If your coach has a white trim panel, check the corresponding white-finish Lippert switch part number before ordering to avoid a visible mismatch.

Installation Overview

Replacement is typically a simple process:

  • Disconnect shore power and confirm the slide-out is fully retracted or safely supported before working on the switch.
  • Remove the trim bezel or panel screw(s) securing the old switch.
  • Pull the switch body out far enough to access the rear terminals.
  • Note or photograph the wire positions on the 3 terminals before disconnecting.
  • Unplug or remove the terminal connectors from the old switch and transfer them to the new 225487 in the same positions.
  • Seat the new switch in the panel cutout and reinstall the bezel or screws.
  • Test slide extension and retraction before returning the coach to service.
Maintenance Tip: While the panel is open, inspect the wiring terminals for corrosion or looseness. A clean, tight connection at the switch is as important as the switch itself. Use dielectric grease on the terminals after reassembly to slow future moisture ingress.

Part Identification

ManufacturerLippert Components
Part Number225487
Vendor Part #225487
Color / FinishAlmond
Product LineHydraulic Slide-Out Controls

Switch Specifications

Switch TypeMomentary single-pole (SPST momentary)
Terminal Count3 terminals, rear-mounted connector block
Circuit FunctionSignal-level momentary contact for hydraulic control
Actuator StyleInterior panel-mount push/rocker (momentary)

Compatibility

System TypeLippert hydraulic slide-out systems
ReplacesLippert OEM interior switch 225487
Coach ApplicationsFifth wheels, travel trailers, and motorhomes equipped with Lippert hydraulic slide-out systems using this switch style
Color MatchAlmond interior trim panels

In the Box

Included1x Lippert 225487 hydraulic interior switch (almond)
Not IncludedWiring harness, mounting hardware, trim bezel
Important Information
  • This is a signal-level control switch -- it does not directly switch hydraulic pump motor current. Do not substitute a higher-current switch of a different type.
  • Always disconnect shore power and battery before working inside the switch panel to prevent accidental slide actuation during installation.
  • Confirm part number 225487 matches your existing switch before installation. Lippert offers multiple switch variants; an incorrect switch may not function with your control board.
  • This listing is for the almond color only. A white or other color variant will not match almond trim panels.
  • If the slide-out remains unresponsive after switch replacement, the fault may lie with the control board, hydraulic pump relay, or wiring -- not the switch itself.


Browse for more RV Accessories in the same category as this item:

Lippert Repair Parts > Electric and Hydraulic Slide-Out Parts
Lippert Repair Parts