Keep your 5th wheel leveling system working accurately with this genuine Lippert OEM replacement rear remote sensor. Designed specifically for Ground Control automatic leveling systems, this sensor restores proper tilt detection so your rig levels quickly and reliably every time you set up camp.
The Lippert 232201 is the factory-correct remote rear sensor used in Ground Control automatic leveling systems on 5th wheel trailers. If your leveling system is throwing errors, failing to read rear axle angle correctly, or your jacks are cycling without reaching level, a faulty rear sensor is one of the most common causes -- and this direct OEM replacement gets you back to precise, automated leveling without guesswork.
This sensor ships with the wiring harness already attached, making it a straightforward plug-and-play swap for compatible Lippert, HappiJac, and Ground Control leveling control systems. No splicing required on systems with the matching connector.
Factory Lippert part -- no modifications needed for compatible Ground Control systems.
Wiring harness ships attached for a clean, plug-and-play installation.
Designed specifically for the rear mounting location in dual-sensor Ground Control setups.
Works with Lippert, HappiJac, and Ground Control branded auto-leveling control systems.
The remote rear sensor monitors the lateral and longitudinal tilt of the rear of your 5th wheel and sends that data to the Ground Control leveling controller. The controller uses front and rear sensor readings together to calculate the precise jack movements needed to bring the coach to level. A failed or miscalibrated rear sensor causes the controller to make incorrect jack adjustments -- or to fault out entirely. Replacing this sensor restores full closed-loop level feedback.
This sensor is an OEM Lippert part engineered for Ground Control automatic leveling systems on 5th wheel trailers. Compatible leveling brands and labels include:
This is the rear sensor. If your system uses two sensors (front and rear), verify you are ordering the correct position before installing. The front sensor is a separate part.
Ground Control leveling systems have evolved across model years and 5th wheel manufacturers. Some systems use one sensor; others use two (front and rear). Check your Ground Control controller model number and the sensor connector type on your existing harness before ordering to confirm this is the correct replacement for your specific installation. Your RV's wiring diagram or the existing sensor's part number label are the most reliable confirmation methods.