Cracked, faded, or missing idler head cover? This direct OEM-style replacement snaps onto compatible Solera awning idler head assemblies and brings back a clean, finished look while protecting internal components from road debris, moisture, and UV exposure.
The idler head is the non-drive end of your Solera awning -- the side that follows the motor or hand-crank operation without driving the roller tube. Its front cover is a cosmetic and protective cap that shields the internal bearing and pivot hardware from the elements. Over time, these covers crack from UV exposure, get knocked loose at the campsite, or simply go missing during a retraction mishap.
Lippert part number 289566 (vendor cross-reference 37-0325) is the correct replacement front cover for Solera plain idler head assemblies. It is molded in black to match the standard Solera color palette and requires no tools for most installations -- the cover clips or snaps into place over the existing idler head body.
Engineered to the same dimensions as the original Lippert Solera plain idler head front cover -- no trimming or modification needed.
Shields the idler head bearing area from dirt, road grime, moisture, and UV degradation that can accelerate wear on internal components.
Designed for the plain (non-pitched, non-angled) Solera idler head style used on many flat and standard-pitch awning configurations.
Clips or snaps onto the existing idler head assembly. No special tools required for most installations on compatible Solera awnings.
Beyond protection, the front cover gives the awning head a factory-finished look. A missing or cracked cover exposes bare hardware that can corrode and degrade the overall appearance of your rig -- especially problematic for full-timers and those who take pride in campsite presentation.
Lippert offers several Solera idler head variants: plain (flat mount), short, and pitched versions that angle the awning fabric for water runoff. This part number -- 289566 -- is specifically for the plain idler head configuration. If your awning uses a pitched or short idler head assembly, verify the correct replacement cover before ordering. Check the sticker on your existing idler head body or consult the Lippert Solera parts diagram for your specific awning model.
The plain idler head design is used on both Lippert Solera power (electric) awnings and manual awnings across a wide range of RV makes and model years. The idler side is identical between the two drive types -- only the drive head differs.