A direct-replacement in-wall controller for compatible Lippert LCI electric slide-out systems. Restore full extend and retract control when your original unit fails -- without cutting wires or modifying the slide mechanism.
The Lippert 697096 is a genuine OEM-replacement in-wall slide controller designed for Lippert OneControl-equipped electric slide-out systems. When the wall-mounted controller malfunctions -- stuck in one direction, unresponsive buttons, or no movement at all -- this assembly replaces the entire control unit so you are not chasing individual component failures.
Because it is engineered specifically for LCI slide-out systems, the 697096 installs into the existing in-wall cutout and connects to the same wiring harness as the original unit. No rewiring, no improvised adapters. This is the correct part when Lippert technical support or your RV service center identifies the wall controller as the failed component.
Engineered to replace the original Lippert in-wall slide controller. Fits the existing wall cutout and harness connector.
Compatible with Lippert LCI OneControl electric slide-out systems found on many late-model travel trailers and fifth wheels.
Provides full slide-out extend and retract operation from a single in-wall mounted switch assembly.
Sold under Lippert part number 697096 (vendor reference 08-7841). Source directly or through your Lippert-authorized dealer.
Lippert's OneControl system is a CAN-bus-based control architecture used across many RV brands. The in-wall slide controller is the user-facing switch panel that sends extend and retract commands to the slide-out motor or actuator. The 697096 assembly includes the switch interface and harness connector needed to restore operation when the original panel fails.
Common failure symptoms that point to the wall controller (rather than the motor or main control board) include: buttons that click but produce no movement, a slide that only moves in one direction from the wall switch, or a wall panel with no indicator lights while the slide still responds to a handheld remote or the main OneControl hub.
The controller mounts in a standard in-wall enclosure cutout. Disconnect the existing harness, remove the old unit, insert the 697096 assembly, and reconnect the harness. No splicing is required on systems that originally used this controller. Some OneControl installations may require a configuration step at the main hub after replacement -- refer to the system documentation for your specific coach or contact Lippert technical support to confirm whether the replacement unit needs to be paired or addressed on your network.
The 697096 is designed for LCI OneControl electric slide-out systems. It is not a universal slide controller and will not directly replace hydraulic slide controllers, SchwinTek in-wall slide systems, or Lippert slide-out systems that use an older non-OneControl architecture. Match your existing part number before purchasing.
Before ordering, locate the part number on your existing wall controller. Lippert uses several different in-wall slide controller assemblies across OneControl generations. The 697096 is the correct replacement only when your installed unit carries the same or a superseded part number. If your coach uses a different Lippert slide module (such as a ground control or slide-out ECU), a different replacement part is required.