Instructions For Use
Prep First
Park in a shaded area (50°F–75°F).
Clean the damaged area with the alcohol wipe.
Use the push pin to clear loose glass. Place a cloth below the repair area to catch drips.
Step 1: Mount Adhesive Disc
Peel off one side of the adhesive disc and center it over the damage with the tab pointing up.
Press firmly, checking for air bubbles from inside the vehicle.
Peel the other side and press the pedestal onto it, aligning the tab and sealing it tight.
Step 2: Add Resin
Cut the tip off the resin tube (away from your face/paint).
Insert tip into pedestal and squeeze resin into it.
Remove tube, wipe clean, and recap for later.
Step 3: Apply Pressure with Syringe
Push plunger all the way in, then twist syringe into pedestal.
Pull plunger up and lock it in the lower notch using the clip.
Let sit for 10 minutes.
Step 4: Reverse Pressure
Remove syringe briefly to let in air, then reattach it.
Push plunger down and lock in upper notch.
Let sit for 20 minutes.
Step 5: Remove Hardware
Detach syringe, pedestal, and disc.
Use razor to remove leftover resin from glass.
Step 6: Final Fill & Cure
Apply remaining resin to any visible pit.
Place curing strip over the resin.
Smooth gently with razor to remove bubbles.
Move vehicle into direct sunlight for 15 minutes (1 hour if cloudy).
Peel off curing strip once resin hardens.
Finishing Touch
Use razor to scrape off any excess cured resin.
Clean area with alcohol wipe.