The Lippert Solera Awnbrella Hanger Block (part 386206) is the dedicated mounting block that secures the Awnbrella support bow to the exterior wall of your RV, directly beneath the awning hanger rail. If your original block is cracked, missing, or worn, this direct OEM replacement gets your Awnbrella system back in service quickly and correctly.
The Awnbrella support bow is what gives your slide-out awning or door awning its shape and rigidity against wind and rain. The hanger block is the anchor point that holds that bow against the RV wall when the awning is open. Without it, the bow can shift, sag, or pull away from the wall -- reducing the awning's effectiveness and potentially stressing the fabric and arms.
This replacement block installs on the outside wall of your RV beneath the awning hanger rail using standard fasteners. The geometry is matched to the Solera Awnbrella system, so the bow sits at the correct angle without improvised shimming or adapters.
Engineered specifically for Lippert Solera Awnbrella systems -- not a generic block. Matches original mounting geometry.
Installs on the RV exterior wall beneath the awning hanger rail, holding the support bow at the correct position.
Manufactured domestically to Lippert quality standards. A direct OEM-sourced replacement part.
One hanger block per package. Order the quantity you need -- some Awnbrella configurations use more than one block per awning.
Lippert's Solera Awnbrella is a slide-out or door awning system that uses a support bow to hold the awning fabric at an angle, shedding rain away from the slide room or entry door. The hanger block is the interface between the bow and the RV wall -- it captures the end of the support bow and keeps it locked against the exterior surface so the awning maintains proper pitch and tension.