A clean, low-profile interior light solution for RVs, campers, and trailers. The Camco 41320 double dome fixture runs on 12V DC power, mounts to ceiling or wall, and ships complete with two #921 replacement-grade bulbs and dome covers -- so you can have it lit the same day it arrives.
The Camco 41320 is a straightforward, no-guesswork dome light designed for RV interiors. The dual-dome layout spreads light across a wider area than a single fixture, making it a good choice for slide-outs, galley areas, bathrooms, and entry ceilings where a single point of light falls short.
The clear lens keeps light output clean and unfiltered. At 12 inches long and just 1.5 inches in profile, it sits flush and unobtrusive against any interior surface. Installation uses standard hardware you likely already have on hand -- or the included self-tapping screws for common RV wall and ceiling panels.
Two dome covers in one 12-inch fixture deliver broader, more even light spread than a single dome unit.
Ships with two #921 bulbs pre-selected for this fixture. No separate bulb purchase needed to get started.
Mounting holes support both orientations. Works on standard RV ceiling panels and interior sidewalls.
Connects via 18 AWG wire nuts (two required, not included) to your existing 12V DC circuit. No special tools needed.
Note: Wire nuts (18 AWG, qty 2) and #8 self-tapping mounting screws (qty 8) are required for installation but are NOT included in the package.
When a bulb burns out, replace it with a standard #921 wedge-base bulb. This is one of the most common RV interior bulb types and is stocked by virtually every RV parts retailer and auto parts store. You can also upgrade to a #921 LED equivalent to reduce draw and extend bulb life -- the socket is compatible with LED wedge-base replacements of the same format.
Mount the fixture base to your ceiling or wall surface using four #8 self-tapping screws per end cap (eight screws total). Connect the two fixture lead wires to your 12V DC circuit using 18 AWG wire nuts. Snap the dome covers into place over the bulbs. The fixture is rated for indoor use only -- do not install in locations exposed to moisture or direct weather.