A purpose-built wiring solution for 12-volt sprayer pumps, the Remco 901-009-R gives you 90 inches of heavy-duty 16 AWG bonded copper wire, a 30 amp on/off switch, standard 2-pin SAE connectors on both ends, and two 12-inch extension leads so you can power your pump from a battery or a 12V vehicle outlet -- no improvised splicing, no undersized wire.
Undersized wire and flimsy switches are the leading cause of sprayer pump failures in the field. The Remco 901-009-R eliminates that risk by pairing heavily insulated 16 AWG bonded copper conductors with a 30 amp rated on/off switch -- well above the draw of even high-output 5.3 GPM sprayer pumps. The result is stable voltage delivery, minimal heat buildup, and a switch that holds up to repeated cycling in wet, dusty, and vibration-prone environments.
Both ends of the 90-inch main harness terminate in the standard 2-pin SAE connector used across Remco's 2200, 2400, 3200, 3300, and 5500 Series pumps as well as many competing brands. The kit also includes two 12-inch extension leads -- one with 30 amp battery clips for direct battery connections and one with a 12-volt car adapter plug for cab or accessory outlet hookups.
Red and black bonded pair with heavy insulation. Handles up to 30 amps continuously for low-resistance power delivery across the full 90-inch run.
Heavy-duty switch rated for repeated cycling. Controls pump power without interrupting the circuit at the battery -- no need to disconnect leads to stop the pump.
Both ends use the industry-standard 2-pin SAE plug compatible with Remco pumps and most other 12V sprayer pump brands. Plug-and-play installation, no crimping required.
Includes one 12-inch lead with 30 amp battery clamps and one 12-inch lead with a 12V car adapter. Power from a dedicated battery bank or a vehicle accessory outlet.
This harness is engineered for 12-volt demand sprayer pumps operating between 1.0 GPM and 5.3 GPM. Confirmed compatible pump families include:
The 90-inch main harness bridges the distance between your power source and the pump mounting location -- enough reach for most ATV, UTV, skid sprayer, and pickup bed installations. Route the harness away from sharp edges and heat sources, secure with zip ties, and connect the appropriate 12-inch extension to your power source.