Keep debris and contamination out of your sprayer pump with Remco's MF-34F34M-R inlet filter strainer. Designed to install directly on the inlet side of your pump, it uses a chemically resistant 50 mesh screen to trap particulate before it reaches the pump head -- extending pump life and protecting spray tips from clogging. The clear polypropylene bowl lets you check screen condition without opening or draining anything.
Sprayer pump failures most often trace back to debris ingestion -- grit, sediment, and particulate that enter through the inlet and score pump components or block check valves. The Remco MF-34F34M-R sits between your liquid supply and pump inlet, filtering that material out before damage can occur.
The 3/4" quick attach connections make it straightforward to integrate into existing plumbing on most demand-activated sprayer pumps. One end is a standard 3/4" female thread for your supply line; the other is a 3/4" quick attach fitting that mates directly to Remco pump inlets and compatible aftermarket setups.
Chemically resistant mesh traps particulate and debris at the inlet before it reaches pump internals or spray tips.
Transparent polypropylene bowl lets you inspect screen loading and debris buildup at a glance -- no disassembly required.
3/4" quick attach outlet fits Remco pump inlet ports directly, reducing adapters and potential leak points.
Adaptable to Remco 3200, 3300, 5500, and Fatboy series pumps, plus many other brands with compatible 3/4" quick attach inlets.
This strainer is confirmed compatible with the following Remco pump series:
The 3/4" female thread inlet accepts standard hose barb or threaded fittings from your tank or supply line. If your existing plumbing uses a different connection standard, verify thread compatibility before ordering.
A clogged inlet strainer causes the pump to cavitate and run dry, which accelerates internal wear. Remco recommends cleaning the 50 mesh screen regularly -- frequency depends on your liquid type and particulate load.
Install this strainer on the suction (inlet) side of your pump, between the liquid source and the pump inlet port. Flow direction matters -- ensure liquid enters through the 3/4" female threaded port and exits through the 3/4" quick attach side toward the pump. Hand-tighten the bowl after screen inspection; over-tightening the polypropylene body can crack the housing.