Put pump control wherever it makes sense in your rig. The Remco 901-RC02-R lets you switch your Fatboy or Smoothflo water pump on and off from up to 75 feet away, using a sealed, weatherproof remote that connects via a standard SAE 2-pin plug. No more hiking back to the pump bay every time you need to cut water pressure.
Remco's Fatboy and Smoothflo pump series are built for higher-demand RV applications where standard switches fall short. The 901-RC02-R is the matching remote switch engineered specifically for these pumps -- handling up to 40 amps on 12V or 24V DC systems without the heat buildup that underrated switches cause over time.
The remote housing is fully sealed against dust and moisture, making it a solid choice whether you mount it at a galley, at the entry door, or in an outdoor wet bay access panel. Heavy-duty 12 AWG wire handles the current load and resists the abrasion that thinner wire suffers in RV environments.
Switch your pump from virtually anywhere in the coach. The included wiring reaches up to 75 ft from pump to switch location.
Dust and moisture-resistant enclosure keeps the switch reliable in wet bays, under-sink locations, and outdoor compartments.
Onboard LED tells you at a glance whether the pump circuit is live -- no guessing when the pump is on standby or active.
Standard SAE 2-pin connector pairs directly with compatible Remco Fatboy and Smoothflo pump harnesses -- no splicing required.
In many Class A, Class C, and fifth-wheel layouts, the water pump is tucked into a rear basement compartment or beneath a mid-coach cabinet -- easily 20 to 50 feet from the kitchen or bathroom. The 901-RC02-R's 75-foot capability covers most production RV floor plans without extension wiring. If your layout is especially long, measure the actual wire run (not straight-line distance) before installation.
The SAE 2-pin connector on the 901-RC02-R is matched to Remco Fatboy and Smoothflo pump wiring harnesses. Installation is straightforward: route the wire, connect the plug, mount the switch panel. No relay or additional wiring components are required for compatible pumps.
Many aftermarket remote switches ship with 16 or 18 AWG wire that's undersized for high-draw pumps. Remco spec'd 12 AWG on the 901-RC02-R to match the Fatboy and Smoothflo current draw without voltage drop or heat. That wire gauge is also more resistant to chafing against metal edges during the routing process in tight RV bays.
The 901-RC02-R is rated for both 12V and 24V DC operation, matching the dual-voltage capability of the Fatboy and Smoothflo pump families. Verify your pump's operating voltage before installation and confirm your RV's DC system voltage matches.
This switch is designed specifically for Remco Fatboy and Smoothflo series pumps. It is not a universal pump switch and is not confirmed compatible with SHURflo, Flojet, or other brand pumps without verifying connector and voltage compatibility. Do not use this switch on AC pump systems.