Stop wrestling with loose rubber pads every time you level your rig. The SnapPad XTRS5SP4 snaps directly onto LCI (Lippert Components) Power Star landing gear legs and stays there permanently -- through travel, rain, mud, and rocky terrain. When you drop your jacks, the pad is already in place and ready to spread the load.
Loose block pads and rubber mats have a way of disappearing under the frame, sliding off on soft ground, or sitting back in the storage bay while you are already halfway through leveling. SnapPad solves that problem with a snap-on retention collar that locks onto the round foot of LCI Power Star landing gear legs. The pad travels with the leg -- up or down -- every single time.
The XTRS5SP4 is purpose-built for the round foot profile of the LCI Power Star series, which is one of the most common heavy-duty landing gear systems found on 5th wheel trailers from manufacturers including Grand Design, Keystone, Forest River, Alliance, and others. If your 5th wheel came from the factory with LCI Power Star legs (often listed as "Lippert Power Star" in owner docs), this is the correct SnapPad SKU.
Retention collar grips the round foot of LCI Power Star landing gear -- no tools, no adhesive. Stays attached through road travel and repeated use.
12 x 9 inch footprint distributes tongue-and-landing-gear weight over a larger surface area, reducing sinkage on soft soil, gravel, and asphalt.
Molded from high-density rubber that resists UV, ozone, and temperature extremes -- stays flexible in cold weather without cracking or stiffening.
Forget bending down to place pads before every setup. The SnapPad is already on the leg and ready the moment your jacks touch down.
The XTRS5SP4 is designed specifically for the LCI (Lippert Components) Power Star landing gear system used on 5th wheel trailers. This system features a round foot pad at the base of each front landing leg. The SnapPad retention collar is sized and shaped to snap securely onto that round foot profile.
Traditional approaches -- rubber pads, wooden blocks, Lynx levelers -- work, but they require you to carry them, remember them, place them correctly before jack contact, and retrieve them before you pull out. Leave one behind and you are driving down the road dragging a pad. SnapPad eliminates all of that by making the pad a permanent part of the landing gear leg itself.
Many campgrounds and RV parks enforce rules against point-loading paved surfaces with bare metal jacks. The 12 x 9 inch base of the XTRS5SP4 spreads the leg load across a much larger contact area, reducing PSI on asphalt and concrete. This protects your campsite surface and keeps you in compliance with park rules that require pads under all jacks.
Installation is straightforward. Fully extend the landing gear leg so the foot is accessible. Align the SnapPad retention collar with the round foot of the LCI Power Star leg. Push and snap firmly until the collar seats around the foot perimeter. Retract and re-extend the leg to confirm the pad stays attached. That is the entire process -- typically under five minutes per leg.