Two white StakPad stackable jack pads / leveling blocks with rubber top and base for use under RV jacks, stabilizers, trailer wheels, tires, and other support points.
SnapPad STK2-WHITE StakPads are heavy-duty stackable jack pads and leveling blocks designed for RVs, trailers, commercial vehicles, and other equipment that need a tough support surface. They can be used under leveling jacks, stabilizers, tongue jacks, trailer wheels, tires, or other support points where added height, grip, and surface protection are needed.
Each StakPad uses a three-piece design with a recycled rubber base, thermoplastic middle, and removable recycled rubber top. The rubber layers help add grip and cushion, while the rigid middle section provides strength for heavy loads and stackable support.
Can be stacked in column or pyramid configurations for added height
Designed to support heavy RV, trailer, and vehicle applications
Rubber top and bottom help improve traction and surface contact
Includes two white StakPads for multiple support points or stacking
StakPads are universal support pads and leveling blocks, not permanent snap-on jack foot pads. They are placed under tires, wheels, jacks, stabilizers, or other support points as needed during setup. Always use on stable ground, center the load on the pad, and verify the stack is secure before applying vehicle or jack weight. Do not exceed safe setup practices or use on unstable, sharply sloped, or unsuitable ground.
Before Starting: Park on the most stable surface available and inspect the ground for slope, mud, gravel, soft soil, sharp debris, or other conditions that could affect support. Basic Use Steps: 1. Choose Placement: Select the support point where the StakPad will be used, such as a jack foot, stabilizer, trailer wheel, or tire. 2. Inspect the Pad: Check the StakPad for damage, debris, or foreign material before use. 3. Place on Stable Ground: Set the pad flat on firm ground with the load centered over the pad. 4. Stack if Needed: Stack pads in a stable column or pyramid configuration when extra height is needed. 5. Center the Load: Make sure the jack foot, tire, wheel, or support point is centered and fully supported. 6. Apply Load Slowly: Lower the jack or move the vehicle into position gradually while checking for shifting. 7. Confirm Stability: Make sure the pad, stack, and support point remain flat and stable before relying on the setup.
Package Contents: • 2 SnapPad STK2-WHITE white StakPads NOT Included — May Also Need: • Additional StakPads for more support points or taller stacks • Wheel chocks • Permanent SnapPads for jack feet, if desired • Leveling system components • Trailer or RV jack pads, blocks, or accessories for specialized setups This listing is for one 2-pack of white StakPads only. Jacks, stabilizers, tires, chocks, and additional leveling accessories are sold separately unless otherwise stated.
To confirm this is the right support pad for your setup, have the following ready: • Vehicle or trailer type • Intended use: jack foot, stabilizer, tire, trailer wheel, tongue jack, or other support point • Approximate load and number of support points • Desired stack height • Typical parking surface: concrete, asphalt, gravel, dirt, grass, or mixed terrain • Photos of the jack, stabilizer, tire, or support area, if unsure Why this matters: StakPads are universal placement pads, while permanent SnapPads are selected by jack foot size and shape. Choosing the correct product depends on whether you need a portable support block or a permanent snap-on jack foot pad.
Match StakPad use by support point, pad footprint, stack height, load requirements, and ground conditions. This product is portable and is not the same as a permanent snap-on SnapPad jack foot pad.
If the setup shifts, sinks, or feels unstable, check ground conditions, stack height, load centering, wheel chocking, and support point placement before adding more height or load.