Cable adapter kit for Freedom SW inverter/charger upgrades. Allows compatible Xanbus-enabled Freedom SW devices to use an existing 4-pin RJ11 telephone cable or 6-pin RJ12 Xantrex remote cable, helping reduce installation time when replacing older inverter/charger systems.
The Xantrex 808-9010 Freedom SW Telephone-to-Network Cable Adapter is designed to simplify Freedom SW inverter/charger upgrades by allowing the installer to reuse an existing telephone-style remote cable in many RV and marine installations.
When upgrading from older inverter/charger systems, pulling a new network cable through walls, cabinets, compartments, or finished interiors can be time-consuming. This adapter kit helps establish a Xanbus network connection using an existing 4-pin RJ11 telephone cable or 6-pin RJ12 Xantrex remote cable, reducing the need to run a new cable to the System Control Panel.
Allows many Freedom SW upgrades to use an existing telephone-style remote cable
Helps Xanbus-enabled devices establish communication through existing RJ11/RJ12 cabling
Useful when replacing older inverter/charger systems without pulling a new remote cable
Designed for mobile installations where cable routing can be difficult or labor-intensive
The 808-9010 is commonly used when upgrading to a Freedom SW inverter/charger in an RV, boat, or specialty vehicle that already has a remote telephone cable installed from a previous inverter/charger system. It is intended to support communication cable reuse during Freedom SW installations. It is not a remote display, remote switch, or System Control Panel by itself.
• Xantrex 808-9010 Freedom SW telephone-to-network cable adapter kit • Red adapter • Black adapter
This adapter kit is used when a Freedom SW installation needs to communicate over an existing telephone-style remote cable. The adapter allows compatible Xanbus-enabled devices to establish network communication using installed RJ11 or RJ12 remote cabling. Follow the Xantrex Freedom SW Remote Adapter installation guide for the correct adapter placement, network layout, and Xanbus termination requirements.
Xantrex 808-9010 is a cable adapter kit. It does not replace the Freedom SW System Control Panel, remote on/off panel, network terminators, or other required Xanbus accessories. Verify your existing cable type, Freedom SW model, System Control Panel setup, and network requirements before ordering.
The Xantrex 808-9010 is a Freedom SW telephone-to-network cable adapter kit used to reuse existing RJ11/RJ12 remote cabling during Freedom SW inverter/charger upgrades. It is not a remote panel or control display.