Interior sliding shade for standard 14"×14" RV roof vents. Mylar-backed panel blocks 50% of light and reduces heat gain in summer. Slides open to admit natural light. Installs over existing vent trim using current screws — no modifications needed. Conforms to curved ceilings.
The AP Products 015-201612 is an interior sliding shade for standard 14"×14" RV roof vents. The Mylar-backed shade panel blocks 50% of incoming light through the vent opening, reducing solar heat gain in summer and helping retain warmth on cool spring and fall mornings when the vent is closed but the dome still admits cold air. Slide it open completely to restore full natural light in seconds.
Installation requires no new hardware and no modification to your existing vent trim — the shade mounts over the current vent garnish using the screws already in place. The frame conforms to curved RV ceilings without any cutting or custom fitting, making this a straightforward upgrade for most 14"×14" standard vents.
Mylar-backed shade panel cuts solar heat gain through the vent in summer — keeps interiors cooler without blocking airflow entirely
Reduces cold air infiltration through the vent dome on chilly spring and fall mornings
Slides open in seconds to admit full natural light whenever needed — no tools required to operate
Mounts over current vent trim using the screws already in place — no new hardware, no modifications, no tools beyond a screwdriver
The 015-201612 installs over your existing vent garnish (trim ring) using the screws already securing the garnish to the ceiling — no additional hardware is needed and no new holes need to be drilled. Screws not included — use the existing vent garnish screws. Verify your vent garnish screws are accessible and in good condition before ordering. If your existing screws are stripped or missing, replacements will be needed.
This shade is designed to fit most standard 14"×14" RV roof vents — not all. Verify your vent dimensions against the key measurements below before ordering: Overall shade frame: 16-3/4" × 16-3/4" Mounting hole spacing: 15-3/16" × 11-1/2" Back opening: 13-1/16" × 13-1/16" Front opening: 9-15/16" × 11-5/16" Confirm your existing vent garnish screw pattern matches the mounting hole spacing before purchasing.
• (1) AP Products 015-201612 Sliding Vent Shade NOT Included: • Screws — use existing vent garnish screws
Summer: Close the shade to block 50% of direct sunlight — reduces solar heat gain through the vent dome and keeps interior temperatures lower Spring / Fall: Close on cool mornings to reduce cold air infiltration through the vent area while the rest of the RV warms up Anytime: Slide fully open to restore complete natural light and ventilation through the vent