Voyager Auto-Pairing Wireless Back Up Camera (WVSXC150)

The Voyager WVSXC150 is a WiSight 2.0 digital wireless, auto-pairing backup/observation camera for RVs and trailers. It delivers a clear color image with a high-performance CMOS sensor, 14 IR LEDs for low-light, and a built-in microphone so you can hear spotter cues. Rugged IP69K waterproof housing, quick one-button pairing to a compatible monitor, and 12V DC power make it a clean retrofit or upgrade.

Dimensions & weight

• Camera body (approx.): 2.35" L × 3.36" W × 3.35" H
• Weight (camera only, approx.): ~1.05 lb
• Mount type: Bracket mount (hardware included)

What it does

• Auto-pairs with a compatible WiSight 2.0 monitor for fast setup and clean switching between trailers.
• Backup + observation: Use while reversing or as a constant rear-view while driving.
• Low-light assist: 14 IR LEDs help visibility at dusk, dawn, and in unlit sites.
• Audio monitoring: Built-in mic lets you hear a spotter or campsite noise from behind the RV.

Technical details

• Sensor: Color CMOS (high-performance)
• Wireless: WiSight 2.0 digital link (auto-pairing)
• Ingress protection: IP69K (pressure-wash rated enclosure)
• Audio: Integrated microphone (U.S. Patent 9,054,743)
• IR illumination: 14 LEDs for enhanced low-light imaging
• Field of view: 122° diagonal / 91° horizontal / 65° vertical
• Operating voltage: 12V DC
• Operating mode: Reverse-triggered or constant-on (depends on how you power it)

Compatibility

• Monitors: WiSight 2.0 monitors such as WVSXM70 (7") and WVSXM43 (4.3") (sold separately).
• System: Only for WiSight 2.0; not compatible with first-generation WiSight.
• Power: Any switched 12V DC source on the trailer/RV. For observation while driving, power from an ignition-switched or running-lights circuit as appropriate.

What’s in the box

• WVSXC150 camera
• Adjustable bracket
• Mounting hardware kit (stainless screws/washers)
• Allen wrench
• Documentation

Install & pairing

1. Mount the bracket high and centered for best rear visibility; seal cable pass-through with RV-grade sealant.
2. Provide 12V DC power (reverse light or switched circuit per your use case).
3. On the monitor, hold PAIR ~5 seconds; apply camera power to auto-pair.
4. Adjust tilt to capture the hitch and the horizon; verify audio and IR performance at night.

Warranty & support

• Limited 1-Year Manufacturer Warranty
• RVupgrades phone/chat/email/text support if you need help choosing a monitor or wiring for observation vs. reverse-only

Recommended add-ons

• Voyager WVSXM70 7" WiSight 2.0 Monitor (supports up to 4 cameras)
• 12V wiring kit / sealant for clean installs
• Extra mounting bracket if you switch between trailers