An exact-fit OEM replacement idler cover for the left side of your Carefree Longitude RV awning. Shields the idler wheel from UV exposure, rain, road dust, and debris -- preserving smooth roller operation and protecting the internal mechanism from premature wear.
The idler cover on your Carefree Longitude awning takes constant abuse -- sun, rain, road grime, and the occasional branch. When the cover cracks, fades, or goes missing, the idler wheel and its housing are exposed to the elements, which shortens the life of the entire awning arm assembly. Replacing it with the correct OEM cover keeps moisture out of the idler bracket and maintains the clean, finished look of your awning end cap.
This is the left-side cover -- the idler (non-motor) end of the awning as viewed from outside the RV looking toward the vehicle. If you need the right-side or motor-side cover, verify your awning orientation before ordering. See the fitment note below.
Direct factory-spec replacement for Carefree Longitude awning left-side idler covers. No trimming or modification required.
Molded in white UV-stabilized plastic that resists fading and cracking through years of outdoor exposure.
Mounting hardware is in the box. No separate trip to the hardware store needed for installation.
Designed specifically for the non-motorized idler end of the awning arm -- not interchangeable with the motor-side cover.
The idler cover snaps and screws over the idler wheel bracket at the far end of the Longitude awning arm. It keeps the roller mechanism clean and aligned, prevents water intrusion into the bracket housing, and completes the finished appearance of the awning end cap. Replacing a damaged cover early prevents corrosion and debris buildup that can cause the idler wheel to bind or seize.
Stand outside your RV and face the side where the awning is mounted. The left side is the end of the awning to your left as you face the rig. This is the idler (non-motor) end on most standard Longitude awning configurations. If your awning motor is on the left end (less common), you need the motor-side cover instead. Check your awning arm label or Carefree documentation for your specific configuration before ordering.
R001834-005 is specific to the Carefree Longitude awning series. It is not a universal fit for other Carefree product lines such as the Travel'r, the Campout, or third-party awning brands. Check the label on your awning arm rail or consult your RV owner's manual to confirm "Longitude" before purchasing.
Replacing the idler cover is a straightforward DIY task that typically takes under 30 minutes with basic hand tools:
While the cover is off, inspect the idler wheel for flat spots, cracks, or binding. Wipe out any grit or debris from inside the bracket housing before installing the new cover. A small amount of silicone lubricant on the idler axle pin will help the wheel spin freely and extend its service life.