 |
 |
 |
|
Overview
The Clear2O Replacement Sediment Pre-Filter is designed for CPF1000. This 10-micron polyethylene filter removes silt, sand, sediment, rust, and other particulates from your drinking water, and improves the overall effectiveness of your inline RV filter. The CPF1000 will be the first line of defense capturing and removing particulate matter like dirt, silt, sand and debris from your water, making clean water possible for RV Campers. Must-have Gear for Your Upcoming Road Trips!
Features
- Compact, durable design.
- Backwash extends filter life between changes.
- Washable and reusable.
- Easy to install and replace.
- It is recommended the filter is replaced every 6 months, or as needed.
- Note: Cleaning filter does not restore the original color of the filter. Always connect to a known water source and use a water pressure regulator. Water quality varies depending location and filter life varies. Any particle smaller than 35 microns in size cannot be seen without magnification.
Specifications
- Weight: 1.5 lbs.
- Only works with Clear 2O CPF1000.
Instructions
Clear2O DirtGUARD Replacement Sediment Pre-Filter
|
|
|
 |
|
 |
|
|
|
 |
|
 |
|
Additional Product Information
- A two stage system starts with a good sediment filter that BLOCKS dirt particles that would otherwise clog up the carbon filter more quickly.
- The CLEAR2O® DirtGUARD™ Sediment PreFilter will be the first line of defense capturing and removing particulate matter like dirt, silt, sand and debris from your water. Transforming your inline water filter to into a two stage water filtration system. Ensuring you are using the cleanest possible water.
- Eliminates Silt, Sand, Sediment, Rust & other Particulates.
- Pre-Filter enhances the effectiveness of inline RV Filter.
- Fits most standard Inline RV water filter brands (Not Included).
- Backwashing extends filter life between changes.
- Compact & durable design with ridge Polyethylene filter provides a higher dirt holding capacity.
- Versatile position use - upright or on it's side.
- Recommend to replace filter every 6 months or as needed.
- Installs quickly and easy.
- Includes Pre-Filter Housing, 20 Micron Sediment Filter, Wrench, Backwashing Adapter and Hose Extender.
- Uses DirtGUARD™ Sediment Replacement Pre-Filter model RDG201
- Sediment will clog your filters. If the filter becomes too clogged, then water can’t properly pass through, and the filter is no longer able to do its job. DirtGUARD™ will help block sediment at the 10 micron level, prolonging the life of your inline filter so you can get the cleanest water possible and the most use out of your filter.
- Transforms any inline RV filter into a Two Stage Filtration System which will optimize your carbon filter's performance!
Note: We recommend installation of the DirtGUARD and/or the Inline Water Filter on the spigot side of the water hose versus installing on the RV water inlet fitting.
⚠️ WARNING: This product can expose you to one or more chemicals known to cause cancer and/or birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
|
|
|
|
|
|
|
