OEM replacement outdoor condenser fan motor for Coleman Mach 6535, 6536, 6537, 6636, 6795, and 46515 Series under-floor basement packaged air conditioning units.
The 1468A3029 is the OEM replacement outdoor condenser fan motor for Coleman Mach 6535, 6536, 6537, 6636, 6795, and 46515 Series packaged air conditioning and heat pump units. These are Coleman Mach's under-floor and basement-mount AC systems — units installed out of sight beneath the RV floor rather than on the roof — and the 1468A3029 drives the condenser (outdoor) side of those units.
The motor features a 9-inch shaft and is the outdoor/condenser motor only. On these basement packaged units, the condenser and evaporator sides are driven by separate motors; this part number covers the condenser side exclusively. The companion evaporator (indoor) fan motor for the same series is a separate part.
At 18 lbs, this is a substantial motor assembly — consistent with the larger, higher-capacity compressor and blower configurations used in the two-ton class 6535–6537 and 46515 units. Signs of a failing motor include the unit failing to cool properly, unusual noise or vibration from the condenser section, or the unit cycling on its thermal overload protection. Because the condenser motor is exposed to ambient conditions under the vehicle, debris accumulation and moisture intrusion are common causes of failure on these units.
Designed for Coleman Mach's under-floor packaged AC series — not for rooftop units. Confirm your unit installs beneath the RV floor before ordering.
Drives the outdoor condenser section only. The evaporator (indoor) blower motor for the same series is a separate part number.
9-inch shaft — match this dimension to the original motor before ordering to ensure proper blower wheel fitment and housing clearance.
Substantial motor assembly consistent with the larger compressor and blower configurations in the 6535–6537 and 46515 two-ton class units.
The 1468A3029 is the outdoor condenser fan motor only. The 6535–6537, 6636, 6795, and 46515 units use separate motors for the condenser and evaporator sides. If the indoor evaporator blower is the failed component, a different part number is required. Identify which motor has failed before ordering.
Disconnect and lock out all power before beginning replacement. Note the wiring harness routing, connector positions, and any mounting bracket orientation on the original motor before removal. Verify the 9" shaft length matches the original and that the replacement blower wheel seats and aligns correctly in the housing before securing. At 18 lbs, a second set of hands is recommended for safe handling during removal and reinstallation.
The Coleman Mach 1468A3029 is covered by a 90-day limited manufacturer's warranty against defects in materials and workmanship.
Other parts for the 6535 / 6536 / 6537 / 6636 / 6795 / 46515 basement unit series include the evaporator fan motor (1468A3219), blower run capacitor (1499-5631), and the series bearing (6536-3011). Verify the correct part number for each component before ordering.