OEM replacement screw and washer hardware package for Coleman Mach rooftop AC shroud mounting. Fits a broad range of 47000, 48000, 49000, and legacy 7000/8000 Series air conditioner models. Set of 4.
The Coleman Mach 6792-5111 is the OEM screw and washer hardware package used to secure the outer shroud to the rooftop air conditioner unit. The shroud is held in place by four mounting screws — one at each corner — that fasten through the shroud and into the rooftop unit's basepan or mounting structure. This kit contains the complete set of four screws with washers needed to fully install or reinstall a shroud.
This hardware package is used across a wide range of Coleman Mach models spanning the 47000, 48000, 49000, and legacy 7000/8000 Series rooftop air conditioners. It is the correct OEM fastener package whether installing a new replacement shroud or reinstalling an existing one after service or maintenance. Individual screws and washers lost during travel or maintenance can be replaced with this kit.
Sourcing the correct OEM fasteners ensures a proper fit, correct torque engagement, and a secure shroud installation that resists road vibration and highway travel forces over time.
Includes all four screws and washers needed for a full shroud installation — nothing additional required
Genuine Coleman Mach hardware — correct fastener specification for the shroud mounting points on compatible units
Fits 47000, 48000, 49000, and legacy 7000/8000 Series Coleman Mach rooftop AC models — see compatibility list
Required any time a shroud is removed for AC service, coil cleaning, or shroud replacement
47000 Series: 47201, 47203, 47204, 47214, 47223, 47224, 47234, 47253, 47253, 47273 48000 Series: 48203, 48204, 48207, 48208, 48213, 48253, 48254, 48257, 48263, 48264, 48268 49000 Series: 49201, 49203, 49204, 49211, 49213, 49214, 49221, 49223, 49224, 49231 Legacy 7000/8000 Series: 7332, 7333, 7335, 7373, 7433, 7533, 7632 If your model number is not listed, verify against your unit's parts diagram or contact Coleman Mach technical support to confirm compatibility before ordering.
The shroud is secured with four mounting screws — one at each corner of the unit. When reinstalling a shroud: 1. Position the shroud so it nests correctly with the supply air chute and mounting frame 2. Start all four screws by hand before driving any of them fully 3. Tighten screws evenly, alternating corners to prevent warping or misalignment 4. Do not overtighten — the shroud is polypropylene and can crack if fasteners are driven too hard Always disconnect power to the unit before accessing the rooftop AC for any maintenance or hardware work.
The 6792-5111 spans a broad range of Coleman Mach rooftop AC families. The table below summarizes the series groupings covered by this hardware kit.