The MOR Ryde Extendable Snap-In TV Mount is a great way to save space in your RV, by hanging it up and out of the way. The snap-in design gives you the ability to connect or remove the television quick and easy, without having to remove screws from the VESA plate. This model is made to extend up to 10" outward for better viewing.
Note: This mount is not intended for use on brick, concrete or concrete block. It is up to the installer to decide whether or not the surface area is strong enough to hold the mount with the TV.
- Easy snap-in and removal of TV.
- Type: extendable.
- Mounting type: snap-in mount.
- Load capacity: 35 lbs.
- Mounts flat panel TVs and monitors with VESA patterns.
- VESA sizes: 75 X 75, 100 X 100, 100 X 150 and 200 X 200.
- Holds up to 35 lbs.
- Dimensions: 10.54" width, 8.85" height, 5.3" depth (not extended).
- Extends to 10".
- Includes: wall plate, TV plate and mounting hardware.
- Limited 90 day warranty.
- Made in USA.
If you're looking for a TV mount for your television in your RV, this is a great choice. Most likely you would want to take the TV out at some point, especially if you don't want to leave it in there during the winter, this mount allows you to easily do that. It would work perfect for you if you're trying to conserve space or need to take your TV out at times.
The installation of this mount is simple, the wall plate gets bolted to the wall and then the TV plate to the television, you can then hang the TV on the wall. The TV plate can remain attached to the television and it will easily detach from the wall plate.
Extendable Snap-In TV Mount by MOR Ryde