The GE Profile PLHS13XAHB brings true four-season climate control to your RV rooftop in a low-profile 11-inch package. It cools with 13,500 BTU of capacity and heats efficiently down to 25 deg F using an advanced R-32 heat pump -- reducing your dependence on propane when temperatures dip. Designed for a standard 14-3/8 in. square roof opening, this unit fits the widest range of Class A, Class C, and fifth-wheel applications without a custom adapter.
Most RV air conditioners only cool. The PLHS13XAHB adds a heat pump that efficiently extracts warmth from outdoor air and delivers it inside -- even when outside temperatures are as low as 25 deg F. Below that threshold, the unit automatically switches over to auxiliary heating so you're never left shivering waiting for a mode change.
R-32 refrigerant is the refrigerant of choice in modern high-efficiency equipment. Compared to the R-410A still found in many competing units, R-32 has a lower global warming potential and improved thermodynamic efficiency -- meaning the compressor does less work to move the same amount of heat. For full-timers and extended-season campers, that translates to measurable savings on shore power and reduced generator run time.
Automatic changeover to auxiliary heat below 25 deg F keeps you warm without manually switching modes or firing up the propane furnace.
At 11 inches tall, the PLHS13XAHB clears most campground height barriers and reduces aerodynamic drag compared to taller conventional units.
Next-generation refrigerant delivers higher efficiency and a lower environmental footprint than older R-22 or R-410A systems still in the market.
Engineered for reduced noise output -- a practical priority in campgrounds where sound carries and a good night's sleep depends on it.
The PLHS13XAHB is built around the industry-standard 14-3/8 in. x 14-3/8 in. square roof cutout with a +/- 1/4 in. variance tolerance. This matches the opening found on the vast majority of Class A motorhomes, Class C motorhomes, fifth wheels, and travel trailers built after the mid-1980s.
Required ceiling-to-roof clearance is 2 to 6 inches. This range accommodates most RV ceiling configurations without modification. If your ceiling-to-roof gap falls outside this range, verify the fit before ordering -- units outside the clearance range require a different ceiling assembly or duct adapter.
Running a heat pump at 35-40 deg F is significantly more efficient than burning propane in a forced-air furnace. The PLHS13XAHB lets you stretch a propane tank further on shoulder-season trips where temperatures stay above 25 deg F overnight.
The unit supports multiple heating configurations to match conditions:
The PLHS13XAHB runs on 115V AC / 20-amp dedicated circuit. This is standard for RV shore power hookups and compatible with most 30-amp and 50-amp RV service configurations when wired correctly through the distribution panel. A dedicated 20-amp breaker is required -- do not share this circuit with other high-draw appliances.
At 13,500 BTU, the PLHS13XAHB draws significant amperage during compressor start. If running on a generator, verify the generator's surge capacity can handle compressor startup loads. A soft-start module (sold separately) can reduce startup amp draw and is recommended for generators under 3,500W rated output.
The PLHS13XAHB rooftop unit requires a compatible GE Profile ceiling assembly for full thermostat and mode control. Confirm your existing ceiling assembly is compatible before installing this unit as a replacement. Using a non-matched ceiling assembly may limit available operating modes or void warranty coverage.
GE Appliances backs the PLHS13XAHB with a 2-year manufacturer's warranty covering parts and labor. Warranty service is handled through GE Appliances authorized service channels.