This factory-style wiring plug restores or replaces the critical link between your Kwikee step control module, the 12V power supply, and the door sensor. Built with a male Weather Packard 4-pin connector and pre-measured wire leads, it drops in without splicing or fabricating custom harnesses.
When the wiring harness on your Kwikee electric step fails -- whether from corrosion, rodent damage, or a broken connector body -- the entire step system goes offline. This OEM-specification 4-way plug from Kwikee (Lippert Components) is the direct replacement for the connector that runs from the control module out to the 12V power source and the door ajar sensor.
It uses a male Weather Packard 4-pin connector, the same sealed connector style Kwikee has used on its 32 Series Double Step and Platinum Series steps for years. The harness ships pre-wired with 12 inches of lead wire -- one red 10-gauge wire for the main power circuit and three 16-gauge wires for signal and ground -- so you can identify each lead by gauge and color without guessing.
This part is also cataloged under Kwikee cross-reference number 909306000, so if you have an older parts invoice or a dealer quote showing that number, this is the same component.
Sealed male 4-pin Weather Packard body resists moisture and road debris -- important for an under-coach connection exposed to weather year-round.
Ships with 12 inches of wire already attached: one 10-gauge red (power) and three 16-gauge leads (signal/ground). No splicing at the connector body required.
10-gauge on the power lead handles the current draw of the step motor without voltage drop; 16-gauge on the signal wires keeps the door sensor circuit reliable.
Listed under both Kwikee part numbers 369243 and 909306000 -- confirming fitment against two common catalog references before you order.
This connector mates directly to the matching female socket on the Kwikee step control module. No pin re-wiring, no adapter, and no terminal crimping required at the module side -- the connector body does all the work.
This plug is designed for newer Kwikee 32 Series Double Step and Platinum Series electric steps. If you are unsure of your step series, check the label on the control module box mounted to the step frame or look up your coach model on the Lippert/Kwikee parts lookup. The 32 Series uses a rectangular black module typically mounted between the step arms.
Before ordering, confirm the control module on your step has a 4-pin female Weather Packard socket. Some older Kwikee step series use different connector counts or round DIN-style plugs. A mismatch in pin count means this harness will not mate to your module.