Genuine OEM replacement swivel elbow for Lippert Level Up towable, Level Up motorized, and Lippert motorized hydraulic leveling systems. Restores correct hydraulic line routing without cutting or re-flaring lines. JIC-M to ORB-M adjustable ports. Cross-reference: 6809-04-04. One fitting included.
A leaking or cracked elbow fitting in your Level Up hydraulic system can leave your rig unable to level and create a mess under the chassis. The Lippert 141020 is the genuine OEM swivel 90-degree elbow that routes hydraulic lines at a right angle while allowing rotational adjustment during installation -- so you can align the outlet to the exact position your line routing demands, then lock it down without twisting the hose.
This fitting connects a 1/4 in. JIC male port (the flare-style connection at the hydraulic line) to a 1/4 in. ORB male adjustable port (the O-ring boss fitting at the pump, manifold, or cylinder). The swivel body lets the elbow pivot freely before the jam nut is tightened, eliminating the need to twist the hydraulic hose to reach its seat.
Lippert part number 141020 -- the same fitting installed at the factory on Level Up leveling systems. No guessing on thread spec or body dimensions.
Rotates freely before torquing so the outlet can be aimed at the hydraulic line without twisting the hose or stressing existing connections.
1/4 in. JIC male flare inlet meets 1/4 in. ORB male adjustable outlet -- the standard port combination used throughout Lippert Level Up hydraulic circuits.
Cross-references industry fitting code 6809-04-04. Drops in where the original fitting failed -- no line modifications, adapters, or re-flaring required.
Getting the thread types right is critical when ordering hydraulic fittings. This fitting uses two distinct port standards:
If your existing fittings use different thread types (for example, NPT or ORFS), this specific part is not the correct replacement -- match the thread codes on your original fitting before ordering.
Fixed 90-degree elbows require the downstream hose to be twisted to align with its port, which stresses the hose braid and can cause premature failure. The swivel design on the 141020 lets you position the elbow outlet toward the hose before locking the jam nut -- protecting the hose and making installation significantly easier in tight chassis locations.
The 141020 fitting is used in Lippert hydraulic leveling systems that route 1/4 in. hydraulic lines. Verified compatible applications include:
If you are unsure which fitting your system uses, compare the thread types and body dimensions on the original failed fitting to the specs on this page, or reference Lippert service documentation for your specific leveling system assembly.
This fitting cross-references to Parker/Brennan/Eaton fitting code 6809-04-04 -- a 1/4 in. x 1/4 in. swivel 90-degree JIC male to ORB male adjustable elbow. If your parts supplier uses this code, it refers to the same fitting configuration. Lippert part number 141020 is the correct OEM version for these leveling systems.
Any time a hydraulic fitting is replaced, a small amount of fluid is lost. Check the reservoir level after installation and top off with the fluid type specified by Lippert for your system (typically ATF Dexron III or equivalent, but confirm in your system documentation). Running the system low on fluid can cavitate the pump.