Keep your slide-out operating smoothly and sitting flush with the correct passive-side flush head. The Lippert 163049 is a direct replacement adjustable flush head assembly engineered for 2" x 2" through-frame electric and hydraulic slide-out systems. If your slide-out is sagging, binding, or no longer sitting flush when retracted, this is the component that corrects it on the follow (passive) side of the mechanism.
Lippert's through-frame slide-out systems use flush head assemblies to guide and support the slide tube as it extends and retracts. The flush head on the passive/follow side does not drive the slide -- it follows the motion and keeps the tube aligned and seated correctly when the room is closed. Over time, these components wear, corrode, or lose their adjustment range, leading to uneven travel and a room that won't sit flush against the coach wall.
The 163049 replaces the passive-side flush head on 2" x 2" square-tube systems used across a wide range of electric and hydraulic slide-out configurations. It is sold as an individual assembly and is adjustable, allowing you to dial in the correct fitment for your specific slide room weight and alignment.
Built-in adjustability lets you fine-tune flush alignment without shimming or fabricating custom spacers.
Designed specifically for the non-drive side of through-frame slide-out systems -- not the motor or ram side.
Matches Winnebago part 202924-01-000 and Keystone RV part 596048 for direct replacement confidence.
Fits the 2 inch by 2 inch square slide tube used in Lippert electric and hydraulic through-frame systems.
This flush head is designed for Lippert through-frame slide-out systems using a 2" x 2" square tube profile. It is compatible with both electric motor-driven and hydraulic ram-driven configurations of this tube size. Cross-reference numbers confirm fitment on Winnebago and Keystone RV models that spec this tube size.
Replacing the flush head on a through-frame slide-out is a straightforward repair for an experienced DIY owner or RV service technician. The slide room will need to be fully extended to access the passive-side flush head mounting location on the frame rail. The adjustable feature allows you to set the correct depth so the slide room sits flush and sealed against the coach wall when retracted.