A solid, no-fuss three-step entry solution for RV doorways up to 24 inches wide. The Lippert 432687 is built from heavy gauge steel with a durable black powder coat finish, features radius-corner diamond groove treads for slip resistance, and extends or retracts with one hand. At 300 lbs rated capacity and a self-locking design, it is engineered for daily use in travel trailers, fifth wheels, and motorhomes with compatible door openings.
The Lippert 432687 is designed around a simple goal: safe, confident entry and exit every time you use your rig. The three-step configuration covers typical RV floor heights, and the 7-inch drop per step provides a comfortable, natural stride whether you are boarding at a campsite or stepping off in a parking lot.
Each tread is 24 inches wide and 8-3/4 inches deep -- wide enough for a full foot placement. The diamond groove pattern channels water away from the tread surface while adding mechanical grip underfoot, reducing the risk of slipping in wet or muddy conditions. Anti-skid performance is built into the tread geometry, not dependent on adhesive strips that wear off over time.
Smooth pivot mechanism lets you fold or deploy the step assembly with a single hand -- no bending down, no kicking the steps into position.
Steps lock automatically in the extended position so they do not fold under load. No manual pin or latch required once deployed.
Radius-corner treads with deep diamond groove pattern shed water and mud while providing consistent grip in wet or dry conditions.
Black powder coat over heavy gauge steel resists rust, UV fading, and road debris better than paint alone -- built for years of outdoor exposure.
The step frame, treads, and mounting bracket are all fabricated from heavy gauge steel -- not aluminum or plastic -- giving the assembly the rigidity needed to handle repeated loading at the full 300 lb rated capacity without flex or wobble. The black powder coat is applied after fabrication, coating edges and weld points that bare paint often misses.
Radius corners on each tread reduce snagging and sharp-edge injuries during use and when brushing past the steps while they are retracted. The bracket itself is sized to bolt directly to the RV frame or entry surround without requiring custom fabrication.
This step is designed for RV entry doors requiring a 24-inch wide tread. It is commonly used as a replacement or upgrade step on travel trailers, fifth wheels, and Class A/C motorhomes with compatible door openings and frame mounting points. Verify your existing step width and mounting bracket spacing before ordering to confirm fit.