A small but important finishing piece for your Solera Power Awning switch installation. This black plastic bezel spacer mounts behind the switch face to fill the gap between the switch kit and your RV wall, giving the control panel a clean, factory-finished appearance. Universal fit for all Solera Power Switch Kits means no guesswork -- if you have a Solera Power awning, this is the right spacer.
When installing or replacing a Solera Power Awning switch, the bezel spacer is what takes the job from functional to finished. Without it, the switch housing can sit proud of the wall surface, leaving an unsightly gap or uneven edge around the control. The Lippert 285077 spacer seats cleanly around the switch cutout and brings everything flush, just like the original factory install.
This part is sold individually and is the OEM-style replacement or upgrade spacer for the Solera Power Switch Kit. It carries OEM cross-reference numbers for several major RV brands, making it the go-to sourcing part whether your rig is a Heartland, Keystone, or Winnebago product.
Compatible with all Solera Power Switch Kits -- no model-specific sizing required.
Made from hard plastic that resists cracking, fading, and easy to wipe clean.
Matches the standard Solera switch kit hardware and most RV interior wall trim.
Simple snap or screw-in placement alongside the Solera switch kit -- no special tools needed.
The bezel spacer is a trim component that sits between the wall surface and the switch bezel face. Its purpose is to account for wall thickness variations or cutout depth differences, ensuring the switch plate lays flat and square against the interior panel. On many RV walls, particularly slide-out or laminated wall sections, a small gap exists that would otherwise leave the switch rattling or looking unfinished. This spacer closes that gap cleanly.
This Lippert part is listed under several RV manufacturer part numbering systems. If you are sourcing this through your RV dealer's parts department or cross-referencing a parts manual, these numbers all point to the same Lippert 285077 spacer:
Installation is straightforward and requires no special skills or tools beyond what is used for the switch kit itself. The spacer positions around the switch housing at the wall cutout point. Secure it per the existing switch kit hardware -- no additional fasteners are typically required. The result is a switch that sits flush, with no visible gap around the bezel edge.