Lippert 2023009670 -- Solera 3000 Series Slide-Out Drive Head Assembly
When your Solera 3000 Series power patio awning stops extending or retracting, the problem is almost always the drive head. This OEM-grade replacement from Lippert swaps out the complete motor unit, gear kit, and housing covers in one assembly -- restoring full power operation without piecing together individual components. Black finish matches the original. Manual override included so you can retract the awning safely during a power outage.
The drive head is the core mechanical unit of any motorized patio awning -- it houses the motor and reduction gearing that extend and retract the awning fabric arm. On the Solera 3000 Series, this assembly is a self-contained unit mounted at the slide-out end of the awning tube. When the motor burns out, gears strip, or the housing cracks, replacing the entire drive head assembly is the fastest and most reliable repair path.
Lippert part number 2023009670 (vendor cross-reference 09-1098) is the direct OEM replacement for this application. Because it ships as a complete assembly -- motor, gear reduction kit, end cap, and outer covers -- you are not mixing old and new components, which is a common cause of repeat failures in piecemeal repairs.
Motor, gear kit, and housing covers included. No separate sourcing of sub-components required.
Built-in manual override lets you retract the awning by hand during a power failure or electrical fault.
Engineered specifically for Solera 3000 Series power patio awnings. Mounts to the existing hardware without modification.
Color-matched black housing blends with the standard Solera 3000 Series awning tube and end cap styling.
Awning fabric, arms, mounting hardware, and wiring harness are NOT included. This is a drive head unit only.
Sourcing a bare motor or just a gear kit for the Solera 3000 is difficult, and mixing old gears with a new motor accelerates wear. A complete drive head swap restores factory performance, gives you matched tolerances throughout the gear train, and typically takes less time than a partial rebuild. For most DIY RV technicians, this is a one-afternoon job with basic hand tools.
The drive head on the Solera 3000 Series is accessed by removing the outer end cap and disconnecting the two-wire motor lead from the awning control harness. The drive head slides out of the awning tube after the retention screw or pin is released. Installation reverses the removal sequence. Always confirm the awning is fully retracted and secured before beginning disassembly.
If you need to retract the awning without power, the manual override on this drive head accepts a standard 3/8-inch drill or hex socket drive. Insert into the override port and rotate in the retract direction. Do not use an impact driver -- controlled hand speed prevents gear damage.
The Solera 3000 Series drive head is NOT interchangeable with the Solera 2000 Series or other Lippert awning families. Check the label on the awning tube end cap or reference the original assembly documentation to confirm "3000 Series" before purchasing this unit.