Direct OEM replacement for the controller and nested touchpad on Lippert Solera Smart Arm RV awnings. Restores full exterior one-touch awning operation without running inside to a wall switch -- exactly where you need it, right at the arm.
When your Solera Smart Arm awning controller fails -- cracked touchpad, unresponsive buttons, water intrusion damage -- this is the OEM assembly that restores it. Lippert part 717666 (vendor part 07-7585) is the complete controller and nested touchpad unit designed to nest directly into the awning arm housing, giving you weatherproof push-button control of your awning from outside the RV.
This is not a universal aftermarket control box. It is the specific assembly engineered for the Solera Smart Arm system, using the same connectors, mounting geometry, and control logic as the original unit. Swap the failed unit out and your awning responds exactly as it did from the factory.
Nested touchpad design integrates directly into the Solera Smart Arm housing for a clean, factory-fit look and easy reach.
Plug-and-play replacement using factory connector pinout -- no wire splicing or adapter harnesses required for compatible units.
Control awning extend and retract from outside the coach, reducing wear on interior wall switches and eliminating trips back inside.
Sourced from Lippert Components, the manufacturer of the Solera awning system -- same part that shipped on your rig originally.
This assembly includes the controller PCB and the nested touchpad as a single replacement unit. It is designed to replace the complete arm-mounted control assembly on compatible Solera Smart Arm awnings.
The Smart Arm controller puts extend and retract commands at your fingertips from outside the coach. No remotes to lose, no wall panel required for basic operation -- just press and go from the arm itself.
This controller and touchpad assembly is designed for Lippert Solera Smart Arm awning systems. Verify your awning model and arm style before ordering. The Smart Arm system uses an arm-integrated controller housing -- if your awning uses a separate wall-mounted keypad only, this is not the correct part. Check your existing arm for the nested touchpad pocket to confirm compatibility.