Stop wrestling with your RV entry door. Lippert's friction hinge kit replaces the frustration of doors that slam shut in a breeze or swing wide and bang your sidewall with smooth, controlled movement you can position exactly where you need it -- held firmly in place like a laptop screen. No door catches, no gas struts, no drama.
Conventional RV door hinges do nothing to control swing. In a crosswind, an uncontrolled entry door can slam into your rig's sidewall or snap shut on you mid-step. The Lippert 5-leaf friction hinge kit adds the friction resistance your door needs to stay exactly where you put it -- open a crack for ventilation, wide open for move-in day, or anywhere in between.
This kit installs over your existing door hinges without removing them. The five-leaf design distributes load across the hinge width for long-lasting hold without loosening over time. Two friction hinges per kit is all that is required for a full door installation.
Independently tested to hold the door securely in place against wind gusts up to 25 mph -- covering typical campground and travel-stop conditions.
Existing door hinges stay in place. The friction hinges mount alongside them, so installation typically takes under 30 minutes with basic hand tools.
Replaces the need for aftermarket door catches or gas strut props. The friction mechanism itself holds any open position without additional hardware.
Fits all LCI-branded entry doors and the Challenger door series 450, 805, 950, 975, and 3000. Check for the LCI sticker or tag on the side of your door frame to confirm.
This kit is designed specifically for LCI-manufactured entry doors. Lippert supplies entry doors to a wide range of RV brands, so compatibility is broad. To confirm your door is LCI, look for the LCI sticker or identification tag on the edge or interior side of your door frame.
A door that swings free in wind can cause real damage -- dented sidewalls, cracked window frames, broken door hardware. These hinges eliminate that risk by keeping the door under control from the moment you open it.
If your door trim and hardware are black, see part number 2020102629 for the same friction hinge kit in a black finish.
No special tools are required. The friction hinges are positioned over or alongside the existing door hinge locations and secured with the included mounting screws. Because existing hinges do not need to be removed, you maintain full door function throughout the installation. Most owners complete the job in under 30 minutes.
Before mounting, open the door to the position you most commonly want it to hold, then set the friction tension so the hinge holds at that angle. Test through the full range of motion before final tightening.
Covered by a limited 1-year manufacturer warranty from Lippert. Retain your proof of purchase for warranty claims.