A sagging, squeaking, or cracked entry door hinge is more than an annoyance -- it can compromise the security and weatherseal of your entire door. Lippert's 20-1546 six-leaf hinge assembly is the direct OEM-style replacement designed for RV entry doors that use the standard 6 leaf configuration, restoring smooth, secure operation and a clean white finish that matches factory trim.
Lippert is one of the largest OEM suppliers of RV structural and door hardware in North America, meaning this hinge is built to the same specifications as the units installed at the factory on a wide range of travel trailers, fifth wheels, and motorhomes. When your original 6 leaf hinge is bent, cracked, corroded, or simply worn loose, this assembly lets you restore the door to proper operation without custom fabrication or fitting.
The 6 leaf design distributes load across the full hinge length, reducing stress at any single pivot point and extending service life compared to lighter 3 or 4 leaf alternatives. At 9.271 inches in length, it suits full-height RV entry door applications where a shorter hinge would not provide adequate support.
Multi-leaf design spreads door weight evenly, reducing wear at pivot points and maintaining door alignment over time.
Full-length hinge sized for standard RV entry doors -- provides the span needed to support heavier door panels without flex.
Factory-matched white color blends with standard RV entry door trim and door frames for a clean, original-look repair.
Backed by Lippert's limited manufacturer warranty for defects in materials and workmanship from the date of purchase.
This hinge is designed for RV entry doors that use the standard 6 leaf hinge configuration. It is compatible with a broad range of travel trailers, fifth wheels, and Class A, B, and C motorhomes that were originally equipped with Lippert-supplied door hardware. Before ordering, verify that your existing door hinge is a 6 leaf style and measure the overall hinge length to confirm the 9.271-inch specification matches your application.
Replacing an RV entry door hinge is a straightforward job for most DIY RV owners. Support the door panel before removing the old hinge to prevent the door from dropping and damaging the frame or door seal. Transfer one leaf at a time if you are doing a single-hinge swap, and check that the door swings freely and latches flush after installation.